92WB Front electric heater

[ronmarabito2002]

Yes Rob. The galvanized box is on the left and the three relays are
in that box. The front relay is on the left.

R.E. (Ron) Marabito, Dallas, TX 92WB40


--- In WanderlodgeForum@yahoogroups.com, "Rob Robinson"
wrote:
>
> Thanks Ron. I'll check it out. When you say the relay on the left do you
> mean 'while looking down in the hole'?
>
> On 23/11/2007, ronmarabito2002 wrote:
> >
> > O.K. Randy, Rob and everyone:
> >
> > Here is the skinny on the faulty front electric heat.
> >
> > I went to the junction boxes and relays under the bedroom closet
> > floor. I first checked all the connections in the junction boxes.
> > They are all connected using these 4 terminal push-on splices. I
> > moved all of them. No change in conditions.
> >
> > Second, I checked the three relays. All three were open with the
> > dash A/C switches off. Next I turned the front A/C switch to ON.
> > Checked to see which relay was activated. It was the relay on the
> > left. Checked all the splices. Went back to the front and Whalla!!!
> > We had front electric heat. It had to be a loose connection in one of
> > the splices at the relay.
> >
> > PROBLEM SOLVED. Thanks Randy for leading me to the right place.
> >
> > The other two relays obviously control power to the other two A/C
> > units.
> >
> > R.E. (Ron) Marabito, Dallas, TX 92WB40
> >
> > --- In
WanderlodgeForum@yahoogroups.com,
> > "ronmarabito2002"
> > wrote:
> > >
> > > This is true. One problem is the fact that the wire is buried and
> > > cannot be traced visually. Randy has given me a place to start, so
> > > that is next.
> > >
> > > R.E. (Ron) Marabito, Dallas, TX 92WB40
> > >
> > >
> > > --- In
WanderlodgeForum@yahoogroups.com,
> > "Rob Robinson"
> > > wrote:
> > > >
> > > > So I'm guessing Ron that your next move is to trace the 120V
line to
> > > find
> > > > the fault. Broken wire or loose connection would be a guess. What
> > do you
> > > > think?
> > > >
> > > > On 22/11/2007, ronmarabito2002 wrote:
> > > > >
> > > > > Everything, including the relay works. There is simply no line
> > > > > voltage going into the relay. I have jumpered the heater and
it is
> > > fine.
> > > > >
> > > > > R.E. (Ron) Marabito, Dallas, TX 92WB40
> > > > >
> > > > > --- In
> > > WanderlodgeForum@yahoogroups.com

> > ,
> > > > > "Jack and Liz Pearce"
> > > > > wrote:
> > > > > >
> > > > > > --- In
> > > WanderlodgeForum@yahoogroups.com

> > ,
> > > > > "ronmarabito2002"
> > > > > > wrote:
> > > > > > >
> > > > > > > My 92WB front electric heater is not receiving power to the
> > relay
> > > > > > > controlled by the thermostat. Does anyone know where the
> > main feed
> > > > > > > comes from or is routed. It is on the same circuit as the
> > > front A/C
> > > > > > > and the A/C has power. I would appreciate any insight.
> > > > > > >
> > > > > > > R.E. (Ron) Marabito, Dallas, TX 92WB40
> > > > > > >
> > > > > > Howdy, Ron.
> > > > > >
> > > > > > I want to be sure that I understand your situation. The bottom
> > lever
> > > > > > on the wall thermostat is set to HEAT. The top lever is pushed
> > > to past
> > > > > > the room temperature. Can you hear the relay/contactor
(behind the
> > > > > > front electrical heater) energizing? Let me know.
> > > > > >
> > > > > > Jack
> > > > > > Regards,
> > > > > > Jack and Liz Pearce
> > > > > > Fulltiming in a 1993 Wanderlodge WLWB
> > > > > >
> > > > >
> > > > >
> > > > >
> > > >
> > > >
> > > >
> > > > --
> > > > Rob, Sue & Merlin Robinson
> > > > 94 WLWB
> > > >
> > > >
> > > > [Non-text portions of this message have been removed]
> > > >
> > >
> >
> >
> >
>
>
>
> --
> Rob, Sue & Merlin Robinson
> 94 WLWB
>
>
> [Non-text portions of this message have been removed]
>