Electrical Gremlins
|
12-04-2007, 05:39
Post: #9
|
|||
|
|||
Electrical Gremlins
That one sounds the most likely. The water heater and the couple of electric
heaters may have exceeded 50 amps on the leg. Since the 50-amp breakers are physically tied together normally everything would go, but it is not unheard of for one side to pop but not strongly enough to dislodge the other leg. The 30 amp would have been on a different breaker. If it isn't the breaker, it would have to be the cord or plugs in the situation described. I would bet on the breaker. On 12/4/2007 at 3:19 PM Harold Prescott wrote: >I just had the same thing happen. It turned out to be a blown breaker >on one leg of the shore power. Reset the breaker at the shore power >end, and I don't know why it blew in the first place. > >Harold Prescott >"85 FC35 >Rackerby, Ca. |
|||
« Next Oldest | Next Newest »
|
Messages In This Thread |
Electrical Gremlins - Pete Masterson - 12-29-2006, 13:16
Electrical Gremlins - Ralph L. Fullenwider - 12-30-2006, 01:28
Electrical Gremlins - rogerwwebb@... - 12-03-2007, 18:51
Electrical Gremlins - erniecarpet@... - 12-03-2007, 19:58
Electrical Gremlins - John - 12-03-2007, 23:38
Electrical Gremlins - John - 12-04-2007, 02:35
Electrical Gremlins - Harold Prescott - 12-04-2007, 03:19
Electrical Gremlins - sfedeli3 - 12-04-2007, 04:49
Electrical Gremlins - Don Bradner - 12-04-2007 05:39
Electrical Gremlins - Gregory OConnor - 12-04-2007, 17:04
Electrical Gremlins - John - 12-05-2007, 05:41
Electrical Gremlins - Juergen - 12-06-2007, 02:36
Electrical Gremlins - Pete Masterson - 12-27-2007, 05:11
Electrical Gremlins - Rob Robinson - 12-27-2007, 07:49
Electrical Gremlins - Pete Masterson - 12-27-2007, 09:22
Electrical Gremlins - Rob Robinson - 12-27-2007, 09:58
Electrical Gremlins - g_man1146 - 12-27-2007, 11:41
Electrical Gremlins - somervillebus - 12-27-2007, 13:07
Electrical Gremlins - Pete Masterson - 12-27-2007, 13:15
Electrical Gremlins - Pete Masterson - 12-27-2007, 13:20
Electrical Gremlins - Gregory OConnor - 12-27-2007, 17:55
Electrical Gremlins - Gregory OConnor - 12-28-2007, 03:57
Electrical Gremlins - Pete Masterson - 12-28-2007, 05:47
|
User(s) browsing this thread: 1 Guest(s)