Engine Swap
|
01-08-2008, 14:38
Post: #9
|
|||
|
|||
Engine Swap
Pete,
I assume you mean there was less white smoke on a cold start? I also have a 1978 N/A coach. I am not ready to do an engine swap but I wondered how you lifted the engine. Did you use a jack from below? Did you pull out the engine and trans together, or did you uncouple them while still in the chassis? And last, but not least, did you photograph the event? Gardner 78FC33 --- In WanderlodgeForum@yahoogroups.com, "susanmarycamilleri" > > I finished ny engine swap today. I replaced the original 3206NA with > a reman 3208 from Reviva ( see http://www.reviva.com). While I had the > engine out I replaced and repaired seberal other things. I installed > a new starter (Elreg distributors ltd $221 for a new starter) a new > Power steering pump (from Hydra steer $518 - Eaton RP1G). Also > replaced the transmission filter and fluid. I sand blasted the > pullies and several engine pieces that I had to swap over. I also did > the swing rad mod. I used #12 hydrolic hoses and fittings in order to > keep the 5-8 ID of the original lines. I read that if you go to 1- 2ID > hoses I read that the flow rate goes from 17GPM to 11GPM. The hoses > were expensive $260 and are rated to 3000psi which is way overkill. > > The engine change out was not that difficult. After removing the rad, > dog house, etc the engine had to be lifted in order for the exhaust > manifolds to clear the main frame rails, then it was straight out the > front. There is only about 1 eighth on an inch on either side. The > rubber fuel lines from the frame of the bus the the engine were in > bad shape. If you ave a bus the same vintage you might want to check > them. Power steering supply line (low pres) was also in bad shape. > > New engine has the 3 ring piston. Initial start was immediate as they > run their engines before they are shipped. Noticiable difference in > the amount of white smoke on a cold start. Also engine is quieter. I > think that my old engine has a bit of piston slap noise and prob some > valve train noise. > > I have not had it on the road yet but am looking forward to see if > there is a power difference. > > Pete > Prairie Dog > 78 Fc 35 foot > Courtenay BC > |
|||
« Next Oldest | Next Newest »
|
Messages In This Thread |
Engine Swap - krminyl@... - 07-05-2006, 11:13
Engine Swap - jwasnewski - 07-05-2006, 14:09
Engine Swap - Leroy Eckert - 07-06-2006, 01:38
Engine Swap - ronmarabito2002 - 07-06-2006, 12:22
Engine Swap - Leroy Eckert - 07-06-2006, 15:14
Engine Swap - Rob Robinson - 07-06-2006, 16:20
Engine Swap - ronmarabito2002 - 07-07-2006, 13:11
Engine Swap - susanmarycamilleri - 01-08-2008, 14:23
Engine Swap - Gardner Yeaw - 01-08-2008 14:38
Engine Swap - susanmarycamilleri - 01-08-2008, 14:51
Engine Swap - Mike Hohnstein - 01-08-2008, 15:59
Engine Swap - Curt Sprenger - 01-08-2008, 16:24
Engine Swap - Mike Hohnstein - 01-08-2008, 17:31
Engine Swap - Ernest Ekberg - 12-15-2008, 01:05
Engine Swap - Henry Jay Hannigan - 12-15-2008, 08:23
Engine Swap - Richard Gideon - 12-15-2008, 10:18
Engine Swap - rwoodysurplus - 12-16-2008, 14:03
Engine Swap - Chuck Wheeler - 12-16-2008, 14:56
Engine Swap - rwoodysurplus - 12-16-2008, 15:32
Engine Swap - Don Bradner - 12-16-2008, 16:08
Engine Swap - rwoodysurplus - 12-16-2008, 16:14
Engine Swap - Don Bradner - 12-16-2008, 16:28
Engine Swap - rwoodysurplus - 12-16-2008, 16:32
Engine Swap - timvasqz - 12-16-2008, 17:19
Engine Swap - birdshill123 - 12-17-2008, 03:33
Engine Swap - Don Bradner - 12-17-2008, 03:52
Engine Swap - Rob Robinson - 12-17-2008, 05:31
Engine Swap - Michael Day - 12-17-2008, 09:49
Engine Swap - Gardner Yeaw - 12-17-2008, 10:54
Engine Swap - timvasqz - 12-17-2008, 11:19
Engine Swap - birdshill123 - 12-17-2008, 14:45
|
User(s) browsing this thread: 2 Guest(s)