Bendix cruise control
|
01-13-2008, 02:07
Post: #19
|
|||
|
|||
Bendix cruise control
Hi Dick:
Nice place to be, Canyon Lake area. Cruise are obsolete and to my knowledge not available as new any longer. It may just be a matter of lubrication being needed too. One thing that should not hurt to try is, using CRC spray lube, remove an air line just prior to a valve and spray CRC into the air line the re connect and apply air. This should lubricate the dry o-rings and so forth and may free things up a bit. Just a thought, I know I have done this to my unit and others and it helped, just don't over do it. The CC-5 cable can be lubricated as well. Safe travels, Ralph and Charolette Fullenwider 84FC35 "Ruff Diamond" Duncan, Oklahoma At 01:59 PM 1/13/2008 +0000, you wrote: >Morning Ralph & Bill: Is there a way to clean or service those two >solenoid valves? Are the replacements available through Bendix? My >understanding is that these valves are mounted inside the approx 12"X >16" steel case behind the drivers side battery box on the 1988 FC. > >Bill...have you removed the throttle cable to clean & lubricate? > >Thanks from keeping this CC/fast idle discussion going. > >Dick Gideon >Freedom Bird >1989 35FC35 >On the Road at Canyon Lake, TX > > > >--- In WanderlodgeForum@yahoogroups.com, "Ralph L. Fullenwider" > > > > > Morning Bill: > > > > There are 2 valves mounted on or near the control unit. I would >suspect one > > of those are sticking from time to time on you for the high idle. Since > > your cruise is working the cc-5 is working and that is in drive but >when in > > N the air should be metered from those valves to the inversion valve >and > > conversely the cc-5. Back up a step or 2 from the cc-5 and see what you > > come up with is where I would start. > > > > Safe travels, > > > > Ralph and Charolette Fullenwider > > 84FC35 "Ruff Diamond" > > Duncan, Oklahoma > > > > At 12:56 PM 1/13/2008 +0000, you wrote: > > > > > > >HELLO RALPH, > > > > > > > > >Thank you for posting these precious documents. > > >But, now I am more confused?????? > > > > > >Our Bendix cruise control works great. It is the high idle > > >on our FC that is intermittent, It occationally takes off > > >and really revs up the 3208, So it can not be trusted or used. > > > > > >One of the troubleshooting tips in the manual is to check the > > >resistance of the potentiometer in the CC-5. > > >Well two of the readings show an open circuit and the third reading > > >is in tolerance. > > >Do you have any advice on where to check further?? > > > > > >Thanks again for all your posts. > > > > > >Bill 88 FC Michigan > > > > > > > > > > > >--- In WanderlodgeForum@yahoogroups.com, "Ralph L. Fullenwider" > > > > > > > > > > > Hello everyone: > > > > > > > > Earlier today, I put some files in a folder in the files section > > >Concerning > > > > the Bendix Cruise Control. It is split up into 3 PDF files and is > > >as > > > > complete a manual as I have been able to put together over the > > >years. The > > > > Manual not only cover advanced trouble shooting, it covers the dip > > >switch > > > > set up of the control module and the math that addresses the "why" > > >of the > > > > dip switch settings. > > > > > > > > Along with these files, I up loaded another PDF file for the 6V and > > >8V air > > > > throttle systems, as these systems on the PT's incorporate the air > > > > throttle. There is another file section that is the text portion > > >explaining > > > > how the air throttle works and the sequence of operation that I > > >wrote a > > > > couple of years ago. > > > > > > > > I hope you find these files helpful. > > > > > > > > Oh for those that have not run across it as yet, on the FC's the > > >high idle > > > > is set with the cruise control where the PT's the cruise is not > > >used but a > > > > separate high idle system comes into play. > > > > > > > > > > > > Safe travels, > > > > > > > > Ralph and Charolette Fullenwider > > > > 84FC35 "Ruff Diamond" (looking good with new oak floors and > > >captains chairs > > > > up front) > > > > Duncan, Oklahoma > > > > > > > > > > > |
|||
« Next Oldest | Next Newest »
|
Messages In This Thread |
Bendix cruise control - mjzakowski - 09-11-2007, 00:57
Bendix cruise control - Richard Hayden - 09-11-2007, 01:18
Bendix cruise control - Mike Hohnstein - 09-11-2007, 02:21
Bendix cruise control - brad barton - 09-11-2007, 03:21
Bendix cruise control - brad barton - 09-11-2007, 03:21
Bendix cruise control - margaret m zakowski - 09-12-2007, 06:05
Bendix cruise control - Richard Hayden - 09-12-2007, 08:34
Bendix cruise control - margaret m zakowski - 09-12-2007, 12:33
Bendix cruise control - xz3kg7 - 09-13-2007, 10:50
Bendix cruise control - erniecarpet@... - 01-12-2008, 08:04
Bendix cruise control - Ralph L. Fullenwider - 01-12-2008, 12:58
Bendix cruise control - Ralph L. Fullenwider - 01-12-2008, 13:37
Bendix cruise control - Richard Hayden - 01-12-2008, 17:44
Bendix cruise control - Glenn Allen - 01-12-2008, 20:36
Bendix cruise control - pattypape - 01-13-2008, 00:56
Bendix cruise control - Ralph L. Fullenwider - 01-13-2008, 01:26
Bendix cruise control - Ralph L. Fullenwider - 01-13-2008, 01:33
Bendix cruise control - Richard Gideon - 01-13-2008, 01:59
Bendix cruise control - Ralph L. Fullenwider - 01-13-2008 02:07
Bendix cruise control - Richard Gideon - 01-13-2008, 02:43
Bendix cruise control - pattypape - 01-13-2008, 03:08
|
User(s) browsing this thread: 3 Guest(s)