Twin bed measurement help

[Chet Geist]

Ralph,

I wish you had asked this earlier in the day. I just came back from the bus barn to see that my bird was still bedded down for this cool weather. I have been looking for new mattresses and had requested and got pricing on a 34" x 78" units. I am almost positive the width to the aluminum trim is 34" the length may be 79" or 80" (need room for my big feet to hang over). If you can wait until next week I can double check these dimensions for you . I will be out of town this weekend and the bus barn is 22 miles from the house< but will be going out here again then.

Chet Geist

1981 FC33 - Austin, Texas

-----Original Message-----
From: WanderlodgeForum@yahoogroups.com [mailto:WanderlodgeForum@yahoogroups.com]On Behalf Of Ralph L. Fullenwider
Sent: Wednesday, January 23, 2008 1:13 PM
To: WanderlodgeForum@yahoogroups.com
Subject: [WanderlodgeForum] Twin bed measurement help

Hello everyone:

Hope all are staying warm this winter and nice gathering out in Q. Well
done to all there.

Having recently finished with a few projects, I am now looking at putting
twin beds into the bed room. I need the measurement from the wall to the
inside edge of the bed platform and was hoping some one with twins might
supply that info? I know the mattress is 32 X 79. Also if you have the
metal edging on the out side (aisle) edge would you measure that as well
please.

The island bed in the PT's is nice but in an FC the wife or I are crawling
over one another to get up in the dead of night and that is not making for
good sleeping.

Thanks for the measurements in advance.

Safe travels,

Ralph & Charolette Fullenwider
'84 FC35 "Ruff Diamond" (with a list of things done and yet to do)
Duncan, Oklahoma