Twin bed measurement help
|
01-23-2008, 12:55
Post: #10
|
|||
|
|||
Twin bed measurement help
Ernie:
Electrical shop in Seguin got it overnight (Bryant 7869.) It came without the cable clamp/rear seal, so I reused the old one---scorched but not melted. To make the minimum, I also got the connector for the coach end of the cable. In the catalog it was shown as steel, but on arrival it was nylon and twice as long. I did not change the cord. Are you off for the frozen tundra soon? Was 17 degrees each morning in Pecos, Deming, and Benson as I was en route to Quartzsite. --M.R.Kane 1985 PT 40 Q, AZ --- In WanderlodgeForum@yahoogroups.com, erniecarpet@... wrote: > > Michael Kane, did you get a new receptacle for your power cord? > > Ernie Ekberg > 83PT40 > Weatherford, Tx > > |
|||
« Next Oldest | Next Newest »
|
Messages In This Thread |
Twin bed measurement help - Ralph L. Fullenwider - 01-23-2008, 07:13
Twin bed measurement help - erniecarpet@... - 01-23-2008, 07:35
Twin bed measurement help - erniecarpet@... - 01-23-2008, 07:42
Twin bed measurement help - erniecarpet@... - 01-23-2008, 08:00
Twin bed measurement help - Jon - 01-23-2008, 08:46
Twin bed measurement help - Ralph L. Fullenwider - 01-23-2008, 12:21
Twin bed measurement help - Scott Forman - 01-23-2008, 12:21
Twin bed measurement help - Chet Geist - 01-23-2008, 12:34
Twin bed measurement help - mrkane1952 - 01-23-2008, 12:39
Twin bed measurement help - mrkane1952 - 01-23-2008 12:55
Twin bed measurement help - Jon - 01-23-2008, 14:32
Twin bed measurement help - Ralph L. Fullenwider - 01-23-2008, 15:33
Twin bed measurement help - Chet Geist - 01-23-2008, 15:41
Twin bed measurement help - Ralph L. Fullenwider - 01-24-2008, 00:39
Twin bed measurement help - Ralph L. Fullenwider - 01-24-2008, 00:41
Twin bed measurement help - Ralph L. Fullenwider - 01-24-2008, 00:42
Twin bed measurement help - Peggy & Ed McStay - 01-24-2008, 02:15
Twin bed measurement help - mariopatti1 - 01-24-2008, 03:47
Twin bed measurement help - mrkane1952 - 01-24-2008, 03:57
Twin bed measurement help - Ralph L. Fullenwider - 02-29-2008, 03:55
|
User(s) browsing this thread: 1 Guest(s)