Twin bed measurement help

[Ralph L. Fullenwider]

Thank you Chet.


Safe travels,


Ralph and Charolette Fullenwider

84FC35 "Ruff Diamond"

Duncan, Oklahoma


At 06:34 PM 1/23/2008 -0600, you wrote:

Ralph,



I wish you had asked this
earlier in the day. I just came back from the bus barn to see that
my bird was still bedded down for this cool weather. I have been
looking for new mattresses and had requested and got pricing on a
34" x 78" units. I am almost positive the width to the
aluminum trim is 34" the length may be 79" or 80" (need
room for my big feet to hang over). If you can wait until next week I can
double check these dimensions for you . I will be out of town
this weekend and the bus barn is 22 miles from the house< but will be
going out here again then.



Chet Geist

1981 FC33 - Austin,
Texas

-----Original Message-----

From:[/b] WanderlodgeForum@yahoogroups.com
["WanderlodgeForum@yahoogroups.com"]On
Behalf Of [/b]Ralph L. Fullenwider

Sent:[/b] Wednesday, January 23, 2008 1:13 PM

To:[/b] WanderlodgeForum@yahoogroups.com

Subject:[/b] [WanderlodgeForum] Twin bed measurement help

Hello everyone:

Hope all are staying warm this winter and nice gathering out in Q.
Well

done to all there.

Having recently finished with a few projects, I am now looking at
putting

twin beds into the bed room. I need the measurement from the wall to
the

inside edge of the bed platform and was hoping some one with twins
might

supply that info? I know the mattress is 32 X 79. Also if you have
the

metal edging on the out side (aisle) edge would you measure that as
well

please.

The island bed in the PT's is nice but in an FC the wife or I are
crawling

over one another to get up in the dead of night and that is not
making for

good sleeping.

Thanks for the measurements in advance.

Safe travels,

Ralph & Charolette Fullenwider

'84 FC35 "Ruff Diamond" (with a list of things done and yet
to do)

Duncan, Oklahoma