Twin bed measurement help
|
01-24-2008, 00:42
Post: #16
|
|||
|
|||
Twin bed measurement help
Thank you Mike:
Am happy to see you got the 50 amp service fixed. Safe travels, Ralph and Charolette Fullenwider 84FC35 "Ruff Diamond" Duncan, Oklahoma At 12:39 AM 1/24/2008 +0000, you wrote: >Ralph: > >Do the measurements from a PT help? The metal trim is 1" each side. >The curbside is 35.5" to the aisle edge of the metal trim. The street >side is 38.25", but there are some air conditioner lines running along >the wall, which I covered with a 5" square plastic fence post. I had >mattresses made to fit: 35x80" for the curbside and 32x80" on the >street side. I use standard twin sheet sets. > >--M.R.Kane >1985 PT40 >Q, AZ |
|||
« Next Oldest | Next Newest »
|
Messages In This Thread |
Twin bed measurement help - Ralph L. Fullenwider - 01-23-2008, 07:13
Twin bed measurement help - erniecarpet@... - 01-23-2008, 07:35
Twin bed measurement help - erniecarpet@... - 01-23-2008, 07:42
Twin bed measurement help - erniecarpet@... - 01-23-2008, 08:00
Twin bed measurement help - Jon - 01-23-2008, 08:46
Twin bed measurement help - Ralph L. Fullenwider - 01-23-2008, 12:21
Twin bed measurement help - Scott Forman - 01-23-2008, 12:21
Twin bed measurement help - Chet Geist - 01-23-2008, 12:34
Twin bed measurement help - mrkane1952 - 01-23-2008, 12:39
Twin bed measurement help - mrkane1952 - 01-23-2008, 12:55
Twin bed measurement help - Jon - 01-23-2008, 14:32
Twin bed measurement help - Ralph L. Fullenwider - 01-23-2008, 15:33
Twin bed measurement help - Chet Geist - 01-23-2008, 15:41
Twin bed measurement help - Ralph L. Fullenwider - 01-24-2008, 00:39
Twin bed measurement help - Ralph L. Fullenwider - 01-24-2008, 00:41
Twin bed measurement help - Ralph L. Fullenwider - 01-24-2008 00:42
Twin bed measurement help - Peggy & Ed McStay - 01-24-2008, 02:15
Twin bed measurement help - mariopatti1 - 01-24-2008, 03:47
Twin bed measurement help - mrkane1952 - 01-24-2008, 03:57
Twin bed measurement help - Ralph L. Fullenwider - 02-29-2008, 03:55
|
User(s) browsing this thread: 3 Guest(s)