Muffler for 84PT40 Gererator

[Gregory OConnor]

On my 94pt the manifold is plumbed to a horizontal pipe that slides
in and out the full stroke and the pipe never leaves the female
sleve. Kinda like a trumbone slide. I think the male pipe fixed to
the kubota is stainless steel. The male sleve is solid mounted to a
bracket cantilevered off the engine block. I think the bracket
function is to remove stress on the manifold when the pipe slides in
and out. I dont think there is a muffler in the genset compartment??
Maybe BB has this slide stroke section with nesting ID/OD pipe or a
source for it


GregoryO'Connor
94ptRomolandCa

--- In WanderlodgeForum@yahoogroups.com, "jesupbill"
wrote:
>
> I am having the injector pump and injectors rebuild but still need
to
> replace the muffler on the Kaboto generator motor. From the
manifold it
> is rusted black pipe to a screw on muffler with rusted black pipe
tail
> piece that has to align and slide into the cone for the exhaust.
>
> Need source for replacement muffler and any ideas on keeping the
> threaded pipe aligned properly.
>
> All thoughts appreciated.
>
> Bill Garlen
> 84PT40
> Jesup, GA
>