Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Laminate repair
03-09-2008, 11:01
Post: #14
Laminate repair
Hello Fred,

My coach had a couple of areas where there was damaged laminate when I
bought my coach. When I caused one to occur I understood what caused
the problem. To fix the damage; I found an area on my coach that was
concealed in which I could remove a piece of just the matching
laminate. The clunk of laminate was large enough to scavenge the
repair pieces I needed. I cut /trimmed the damaged laminate with a
Dremel tool and a razor knife. I carefully worked a piece of the
matching laminate with a Dremel/file/knife/sandpaper until it fit
perfectly. I glued the matching pieces in place with adhesive/chalk
that was close to the color of my laminate. I clamped it overnight.
I found someone with a router who just trimmed the outside edge of my
repair. I'll bet a stranger couldn't find the repaired areas unless I
showed them where they are.

All of the damaged areas of my laminate occurred when a door struck
either a cabinet frame or another door when being opened. I prevented
that damage from occurring again by putting shims (thin washers) under
the fasteners for the cabinet doors.

Good luck,

Eric Perplies
currently in Boulder City, NV
96' 42' WBWL
Quote this message in a reply
Post Reply 


Messages In This Thread
Laminate repair - erniecarpet@... - 03-08-2008, 07:32
Laminate repair - erniecarpet@... - 03-08-2008, 08:27
Laminate repair - Fred Hulse - 03-08-2008, 10:19
Laminate repair - ronmarabito2002 - 03-08-2008, 11:33
Laminate repair - Fred Hulse - 03-08-2008, 11:50
Laminate repair - ripsmail2 - 03-08-2008, 12:39
Laminate repair - Fred Hulse - 03-08-2008, 13:13
Laminate repair - Bob Lawrence - 03-08-2008, 13:22
Laminate repair - Fred Hulse - 03-08-2008, 13:23
Laminate repair - Fred Hulse - 03-08-2008, 13:28
Laminate repair - birdshill123 - 03-08-2008, 14:31
Laminate repair - Gregory OConnor - 03-08-2008, 14:54
Laminate repair - Fred Hulse - 03-08-2008, 15:27
Laminate repair - Eric Perplies - 03-09-2008 11:01
Laminate repair - Fred Hulse - 03-09-2008, 15:04



User(s) browsing this thread: 1 Guest(s)