Hooking up a aux. compressor

[freewill2008]

Dan - What make/model compressor did you install?

Thanks
Bob Griesel '84 FC31 WLII WA

>--- In WanderlodgeForum@yahoogroups.com, "Dan Darst"
wrote:
> A year ago, I executed exactly as Jeff described below. Has worked
like a
> pro. I mounted the compressor in the basement compartment just in
front of
> the LR wheel where the battery boilers uste to be housed. Ran a
copper line
> from there to Jeff's hook up point, and put a valve in the line by
the
> compressor so could run air tools off the compressor without airing
up the
> bus.
>
> dandarst86fc35rbhuntleyil.
>
> >From: "Jeff Miller"
> >Reply-To: WanderlodgeForum@yahoogroups.com
> >To: WanderlodgeForum@yahoogroups.com
> >Subject: [WanderlodgeForum] Re: Hooking up a aux. compressor
> >Date: Mon, 16 May 2005 19:44:55 -0000
> >
> >On an '82 FC I'd suggest tying into the wet-tank (curb-side behind
the
> >front axle) output. There is a tee on the rear of the tank, with a
> >shraeder valve, you can attach there, and use a check-valve to
ensure
> >that air can't leak out through your compressor connection. Any
> >pressure between 80psi and 120psi will be fine.
> >
> > - Jeff Miller
> >http://www.wanderlodge.net
> >http://www.millercoachworks.com
> >
> >
> >--- In WanderlodgeForum@yahoogroups.com, "stevecreger"

> >wrote:
> > > Where does one tie in a hookup for a auxially compressor. I'd
like to
> > > do this for the purpose of keeping air to the bus while trying
to
> >find
> > > a very slow air leak while the bus is not running. Also what
should
> >one
> > > regulate to, the pressure of the incoming air.
> > >
> > > Steve Creger
> > > 1982 FC35
> > > Littleton,Co.
> >
> >