Chassis heat problems

[Glenn Allen]

--- In WanderlodgeForum@yahoogroups.com, "Don Bradner"
wrote:
>
> I did not pull and bench test the pump. It is pump design I'm very
familiar with (sold a lot of that design over the years), and is
mighty simple. So long as it turns easily (it does) and has no broken
blades (it doesn't) there isn't much to go wrong. This design has no
problems with blockages - it will turn freely without pumping anything.
>

Don,

Since you are familiar with the pump, maybe you can give me some
advice. I have my pump making some noise randomly. I assume it is
bearing noise. Can these pump bearings be repacked, or with the age
on these pumps would I be better off replacing it with a new pump?

Thanks,

Glenn Allen
1986 PT-40
Marietta, GA