Chassis heat problems

[Don Bradner]

That style will always make a significant amount of noise. Hard to tell if yours
is too much, but if/when it becomes too much, replacement would be the proper
choice.

On 3/18/2008 at 1:47 AM Glenn Allen wrote:

>--- In WanderlodgeForum@yahoogroups.com, "Don Bradner"
> wrote:
>>
>> I did not pull and bench test the pump. It is pump design I'm very
>familiar with (sold a lot of that design over the years), and is
>mighty simple. So long as it turns easily (it does) and has no broken
>blades (it doesn't) there isn't much to go wrong. This design has no
>problems with blockages - it will turn freely without pumping anything.
>>
>
>Don,
>
>Since you are familiar with the pump, maybe you can give me some
>advice. I have my pump making some noise randomly. I assume it is
>bearing noise. Can these pump bearings be repacked, or with the age
>on these pumps would I be better off replacing it with a new pump?
>
>Thanks,
>
>Glenn Allen
>1986 PT-40
>Marietta, GA
>
>
>------------------------------------
>
>Yahoo! Groups Links
>
>
>