suspension issue
|
04-07-2008, 06:48
Post: #6
|
|||
|
|||
suspension issue
Jim:
Power comes from the ignition switch to one side of the suspension dump timed relay coil, the other side of the coil goes to the suspension dump switch. The light is connected to a set of contacts on the suspension dump relay. The other set of contacts go the front and rear suspension dump sensors. This info is off '89/90 prints, that is as close as I can get to your Coach. All of this should be located in the front load center and perhaps on the '88 there is another small valve for the suspension dump and tag dump as well. Sorry I can't get you any closer to your problem than that. Intermittent problems such as this is usually a bad connection rather than a bad component. There are 2 different harness plugs the wires go through as well as the connectors on the relay the switch the dump switch or even the solenoids Safe travels, Ralph and Charolette Fullenwider 84FC35 "Ruff Diamond" Duncan, Oklahoma At 07:56 PM 4/6/2008 -0700, you wrote: Thanks, Ralph |
|||
« Next Oldest | Next Newest »
|
Messages In This Thread |
suspension issue - Jim Riordan - 04-06-2008, 14:31
suspension issue - Ralph L. Fullenwider - 04-06-2008, 14:38
suspension issue - jim riordan - 04-06-2008, 14:56
suspension issue - Gregory OConnor - 04-06-2008, 15:35
suspension issue - jim riordan - 04-07-2008, 03:19
suspension issue - Ralph L. Fullenwider - 04-07-2008 06:48
suspension issue - jim riordan - 04-07-2008, 13:13
suspension issue - Gregory OConnor - 04-07-2008, 16:57
suspension issue - Ralph L. Fullenwider - 04-08-2008, 00:23
|
User(s) browsing this thread: 5 Guest(s)