suspension issue
|
04-08-2008, 00:23
Post: #9
|
|||
|
|||
suspension issue
Greg:
Yes they are pressure switches in the system and are "end of the line" for the electrical control. Safe travels, Ralph and Charolette Fullenwider 84FC35 "Ruff Diamond" Duncan, Oklahoma At 04:57 AM 4/8/2008 +0000, you wrote: >Ralph, my light and a buzzer comes on when the bags bleed out even >if the dump switch is not thrown to dump??? are the 'suspension dump >sensors' pressure switches? >GregoryO'Connor >94ptRomoland Ca > >--- In WanderlodgeForum@yahoogroups.com, "Ralph L. Fullenwider" > > > > > Jim: > > > > Power comes from the ignition switch to one side of the suspension >dump > > timed relay coil, the other side of the coil goes to the >suspension dump > > switch. The light is connected to a set of contacts on the >suspension dump > > relay. The other set of contacts go the front and rear suspension >dump sensors. > > This info is off '89/90 prints, that is as close as I can get to >your > > Coach. All of this should be located in the front load center and >perhaps > > on the '88 there is another small valve for the suspension dump >and tag > > dump as well. > > > > Sorry I can't get you any closer to your problem than that. > > Intermittent problems such as this is usually a bad connection >rather than > > a bad component. There are 2 different harness plugs the wires go >through > > as well as the connectors on the relay the switch the dump switch >or even > > the solenoids > > > > Safe travels, > > > > Ralph and Charolette Fullenwider > > 84FC35 "Ruff Diamond" > > Duncan, Oklahoma > > > > At 07:56 PM 4/6/2008 -0700, you wrote: > > >Thanks, Ralph > > > > > >Jim Riordan > > > > > >"Ralph L. Fullenwider" > > >Jim: > > > > > >I will get into my prints tomorrow and give you the origination >of that > > >signal. > > > > > >Safe travels, > > > > > >Ralph and Charolette Fullenwider > > >84FC35 "Ruff Diamond" > > >Duncan, Oklahoma > > > > > >At 02:31 AM 4/7/2008 +0000, you wrote: > > > >I am wondering if anybody can help me. > > > > > > > >On my 88 WBWL XXV 8V92 the suspension dump light is flashing on >a > > > >regular interval, the suspension is up as well as tag. Does >anyone know > > > >where this light is activated from, my guess is that the switch >or > > > >sensor is bad and sending that suspension dump signal. > > > > > > > > > > > >jim Riordan > > > >772-260-1328 > > > > > > > > > > > > |
|||
« Next Oldest | Next Newest »
|
Messages In This Thread |
suspension issue - Jim Riordan - 04-06-2008, 14:31
suspension issue - Ralph L. Fullenwider - 04-06-2008, 14:38
suspension issue - jim riordan - 04-06-2008, 14:56
suspension issue - Gregory OConnor - 04-06-2008, 15:35
suspension issue - jim riordan - 04-07-2008, 03:19
suspension issue - Ralph L. Fullenwider - 04-07-2008, 06:48
suspension issue - jim riordan - 04-07-2008, 13:13
suspension issue - Gregory OConnor - 04-07-2008, 16:57
suspension issue - Ralph L. Fullenwider - 04-08-2008 00:23
|
User(s) browsing this thread: 2 Guest(s)