Bus won't start

[pattypape]

Hi Ron ,

THis Ignition switch is a Pollak # 31-139
It is a reliable switch, I would guggest checking those
big Amphenal (spell) Connectors, under the dash, the ignition
switch wireing goes thru the connector, near the right side of the
dash.
Look for burnt pins, in the center of the connector.
Clean and lube with electronic contact cleaner, or hard wire around
these few pins connected to the ignition switch.

Good to hear from you,

Bill 88 FC Michigan


--- In WanderlodgeForum@yahoogroups.com, "Ron Hazlett"
wrote:
>
> I have have a 1987 FC that I went to get out of storage.I turned
the
> key and nothing happened. I checked the normal things a/t switch,
> transmission in neutral, batteries charged,and good voltage at
> starter.
> What I found was that when I turned the ignition switch none of
> the dash guages moved, so I pulled the ignition switch. One pin on
> the plug connection was burnt. I checked ignition switch and
> connecting wires. I have no power coming to the ignition. I checked
> at the front lower load center. I had no voltage at the ignition
> connection. My questions are.
> Where does the ignition get its power from?
> Are there any fuses or relays in this circut?
> Does anybody have info on a new ignition switch? I looked in the
> parts database. It listed a part for a 1982 fc. It was Napa
> pt.#ks6599. the switch was for a 1969-75 jeep. I was wondering if
> there were any heavy duty switches avaiable.
> Thanks
>
> Ron Hazlett
> 1987 FC
> The Hideaway
>