Threaded Mode | Linear Mode

05-20-2008, 07:54

Joe,

Even if it would fit, that compartment is soo dirty. Mine (Freedom 458) had already been upgraded when I got it. It is located where I believe the old 1500 watt inverter was located - 3rd compartment back on curb side, just to the rear of the propane tank compartment. This compartment isn't vented to the outside and I was initially concerned about this. However, lack of venting does not seem to be a problem.

Dick Hayden - '87 PT 38 - Lake Stevens, WA

----- Original Message -----

From: "jgarner@dslextreme.com"

To: "WanderlodgeForum@yahoogroups.com"

Sent: Tuesday, May 20, 2008 7:32 AM

Subject: [WanderlodgeForum] Re: Xantrex RV 3012 /2512M Inverter / Charger $$$$$CHEEP $$$$$

--- In "WanderlodgeForum@yahoogroups.com", "bumpersbird"
...> wrote:
>
> I'll call Xantrex in the morning to see how these units compare to the
> Freedom 458's. They are simular but the spec sheet on the 458's are a
> little more detailed.
>
> Clik on or paste the link below. I haven't found prices anywhere close
> to these.
>
> $600 + $70 shipping for a 3000 amp unit & $550, $65. shipping for a
> 2500 amp unit!
>
> These are advertised as new, not remans.
>
> They advertise 50 units available.
>
> http://stores.ebay.com/Sun-Electronics-Miami_Inverter-
> Chargers_W0QQcolZ4QQdirZQ2d1QQfsubZ4QQftidZ2QQtZkm
>
> Kurt Horvath
> 95 PT-42 WLWB

That is a great price! From the Xantrex site it looks like they are
older models.

Specs are here:
http://www.xantrex.com/support/docdisplayarchive.asp
look for the RV series. The new ones end in -GS

Im looking to upgrade from the Pace 1500 in my '87 PT40, do you think
these would fit in the charger compartment??

/Joe