Genset regulator

[Gregory OConnor]

Fred, powertech are 'R&R thinking'their troubleshooting/repair
technique lack the insight the unit build design has. Not that I
know a volt from an amp. I'm still pissed about Robs issue with PT.

With the high ambient heat BB spec'ed into the build, I would use
the same exact VR to replace.

??? is the pegged voltmeter symptom duplicated when you start the
genset unhooked to shore power? could 'transfer switch' have been
the cause of the resulting voltage regulator failure????

GregoryO'Connor
94ptRomolandCa

--- In WanderlodgeForum@yahoogroups.com, "Rob Robinson"
wrote:
>
> Yes it is Fred. Remove the air box and associated piping and don't
lose
> those rubber strips under the air box. They protect against
vibration wear.
>
> 2008/6/4 Fred Hulse :
>
> > Regarding my 15KW generator in my 97 WL,
> > Both voltmeters are pegging the gauge and I am assuming from
talking to the
> > Power Tech folks that the voltage regulator needs changed.
> > I am quite certain it is inside the circuit breaker box behind
the valve
> > cover and air box.
> > Can anyone confirm this?
> > Thanks.
> > Fred & Jeanne Hulse
> > Morristown Arizona
> > 1997 Wanderlodge WLWB41
> >
> >
> >
>
>
>
> --
> Rob, Sue & Merlin Robinson
> 94 WLWB
>