Genset regulator

[robert nloomas]

--- In WanderlodgeForum@yahoogroups.com, "Gregory OConnor"
wrote:
Gregory When the voltage regulator crap out on my 12 KW power tech
I am sure it was due to heat.The regulator had a crack in the top
that ran from one side to the other.
Bob Loomas PT 85
Harahan La.
>
> Fred, powertech are 'R&R thinking'their troubleshooting/repair
> technique lack the insight the unit build design has. Not that I
> know a volt from an amp. I'm still pissed about Robs issue with PT.
>
> With the high ambient heat BB spec'ed into the build, I would use
> the same exact VR to replace.
>
> ??? is the pegged voltmeter symptom duplicated when you start the
> genset unhooked to shore power? could 'transfer switch' have been
> the cause of the resulting voltage regulator failure????
>
> GregoryO'Connor
> 94ptRomolandCa
>
> --- In WanderlodgeForum@yahoogroups.com, "Rob Robinson"
> wrote:
> >
> > Yes it is Fred. Remove the air box and associated piping and
don't
> lose
> > those rubber strips under the air box. They protect against
> vibration wear.
> >
> > 2008/6/4 Fred Hulse :
> >
> > > Regarding my 15KW generator in my 97 WL,
> > > Both voltmeters are pegging the gauge and I am assuming from
> talking to the
> > > Power Tech folks that the voltage regulator needs changed.
> > > I am quite certain it is inside the circuit breaker box behind
> the valve
> > > cover and air box.
> > > Can anyone confirm this?
> > > Thanks.
> > > Fred & Jeanne Hulse
> > > Morristown Arizona
> > > 1997 Wanderlodge WLWB41
> > >
> > >
> > >
> >
> >
> >
> > --
> > Rob, Sue & Merlin Robinson
> > 94 WLWB
> >
>