HWH jack wont extend, 94pt

[Stephen Quandt]

Greg

Every once and a while the switch on mine that is suppose to sense that the brakes are set doesn¢t work right. It is located in the generator compartment high to the left with either a green or green / white wire to both sides (this is from memory, an almost 60 yr old memory).

Try to jump the switch and see if it works.

Steve Quandt

Iron Mountain, MI

1993 PT-40

----- Original Message ----
From: Gregory OConnor
To: WanderlodgeForum@yahoogroups.com
Sent: Tuesday, August 5, 2008 8:06:15 PM
Subject: [WanderlodgeForum] HWH jack wont extend, 94pt

I was preping my bus for radiator removal/rodding and new compressor
cooling lines today and I jacked the jack. I attempted to lift the
back end using two 8x8 timbers under the jack pads to gain some
height for frame jacksstands. the drivers side timber abruptly rolled
a bit in the gravel so I decided to drop the bus and use wider blocks
under the pads. the jacks retracted and I was never able to get the
drive/rear jack to extend once again?

The 94 hwh control pad only allow you to choose a pair of jacks or
auto level ;Both front ;both back ;both left ;both right or auto
level. I tried every combination to extend Drive/rear jack, no luck.

I wonder if I Knocked a sensor loose on the jack or confused the hwh
computer?

GregoryO'Connor
94ptRomolandCa