Black Valves
|
08-20-2008, 15:33
Post: #1
|
|||
|
|||
Black Valves
Hi there
Still going thru shakedown of new unit and tried to open gray and black tanks valves. I was able to twist gray water handle and with some force able to open it, but on the black, i was only able to twist about 90 degrees and it would go no further. Does this mean i am done and need to replace, or is there some way to lubricate or service to try and bring back to life. If i am don, do i replace with another Dupree Products valve, or go to camping world and buy a regular knife type valve and adapt it. Also another newbee question, where is the hot water heater located? I glanced over some post earlier but was not paying attention about water heater stuff so i apoligize about that, but i have opened every door and have not found it yet. Thanks again Paul & Deborah Potter 1987 PT38 Hesperia CA |
|||
« Next Oldest | Next Newest »
|
Messages In This Thread |
Black Valves - ppotter14950 - 08-20-2008 15:33
Black Valves - Curt Sprenger - 08-20-2008, 15:50
Black Valves - Gregory OConnor - 08-20-2008, 16:42
Black Valves - mbulriss - 08-20-2008, 17:41
Black Valves - Curt Sprenger - 08-20-2008, 17:43
Black Valves - Stephen Birtles - 08-20-2008, 23:14
Black Valves - Henry Jay Hannigan - 08-21-2008, 05:10
Black Valves - Richard Gideon - 08-21-2008, 06:51
Black Valves - Gregory OConnor - 08-21-2008, 12:51
Black Valves - Stephen Birtles - 08-21-2008, 12:59
Black Valves - Kurt Horvath - 08-21-2008, 14:47
Black Valves - Greg Young - 08-21-2008, 16:39
Black Valves - Kurt Horvath - 08-21-2008, 17:00
Black Valves - Leroy Eckert - 08-21-2008, 22:33
Black Valves - P & D - 08-22-2008, 04:12
Black Valves - Henry Jay Hannigan - 08-22-2008, 04:16
Black Valves - Bob Lawrence - 08-22-2008, 05:27
Black Valves - Henry Jay Hannigan - 08-22-2008, 14:58
Black Valves - Greg Young - 08-22-2008, 15:05
|
User(s) browsing this thread: 4 Guest(s)