Black Valves
|
08-21-2008, 12:51
Post: #9
|
|||
|
|||
Black Valves
Hank I think electric valves are the ticket because most times when
I dump I have no air to open or close the valve so I do it manualy or have to plan dumping. I just wonder what would happen to the electric motors if the valve's gate encounters an obstacle of a high fiber nature? would the motor stop or continue and damage the gate/ seal and motor?? and the other question is if the electric motor fails can you manualy dump? GregoryO'Connor 94ptRomolandCa --- In WanderlodgeForum@yahoogroups.com, "Henry Jay Hannigan" > > Paul: > Recommend ELECTRIC VALVES.....DRAINMASTER.COM out of Hollister > California......call the factory direct IF u want to save > money....they will even put the attachements on the drainmasters > before they ship them....I put Drainmasters on my 90SP and am very > happy!!! push a button and "BAM" the "stuff" flows..... > make sure you get the "good" switches also..... > u can email me privately IF u have any questions...Also the 2008 > bluebird is using electric dump valves for your information... > Regards, > Hank > 90SP36 > > > > > > > > > > > > --- In WanderlodgeForum@yahoogroups.com, "ppotter14950" > wrote: > > > > Hi there > > > > Still going thru shakedown of new unit and tried to open gray and > black > > tanks valves. > > > > I was able to twist gray water handle and with some force able to > open > > it, but on the black, i was only able to twist about 90 degrees and > it > > would go no further. Does this mean i am done and need to replace, > or > > is there some way to lubricate or service to try and bring back to > life. > > > > If i am don, do i replace with another Dupree Products valve, or go > to > > camping world and buy a regular knife type valve and adapt it. > > > > Also another newbee question, where is the hot water heater > located? I > > glanced over some post earlier but was not paying attention about > water > > heater stuff so i apoligize about that, but i have opened every > door > > and have not found it yet. > > > > Thanks again > > > > Paul & Deborah Potter > > 1987 PT38 > > Hesperia CA > > > |
|||
« Next Oldest | Next Newest »
|
Messages In This Thread |
Black Valves - ppotter14950 - 08-20-2008, 15:33
Black Valves - Curt Sprenger - 08-20-2008, 15:50
Black Valves - Gregory OConnor - 08-20-2008, 16:42
Black Valves - mbulriss - 08-20-2008, 17:41
Black Valves - Curt Sprenger - 08-20-2008, 17:43
Black Valves - Stephen Birtles - 08-20-2008, 23:14
Black Valves - Henry Jay Hannigan - 08-21-2008, 05:10
Black Valves - Richard Gideon - 08-21-2008, 06:51
Black Valves - Gregory OConnor - 08-21-2008 12:51
Black Valves - Stephen Birtles - 08-21-2008, 12:59
Black Valves - Kurt Horvath - 08-21-2008, 14:47
Black Valves - Greg Young - 08-21-2008, 16:39
Black Valves - Kurt Horvath - 08-21-2008, 17:00
Black Valves - Leroy Eckert - 08-21-2008, 22:33
Black Valves - P & D - 08-22-2008, 04:12
Black Valves - Henry Jay Hannigan - 08-22-2008, 04:16
Black Valves - Bob Lawrence - 08-22-2008, 05:27
Black Valves - Henry Jay Hannigan - 08-22-2008, 14:58
Black Valves - Greg Young - 08-22-2008, 15:05
|
User(s) browsing this thread: 6 Guest(s)