Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Xantrex 2.0 Hardware Inverter/Charger
08-24-2008, 15:23
Post: #7
Xantrex 2.0 Hardware Inverter/Charger
I don't know what happened. Transfer shouldn't have been doing anything. The
Prosine docs define the error as an internal one; there are three relays
internally that isolate the output of the inverter from the supply line, and one
of those is welded shut.

On 8/24/2008 at 8:49 PM Chuck Wheeler wrote:

>Full load shouldn't trip the 50 amp breaker. From your error it sounds
>like
>the transfer relay contacts stuck and got circuits crossed up.
>
>- Chuck Wheeler-
>FC 31SB Fort Worth TX
>
>
> _____
>
>From: WanderlodgeForum@yahoogroups.com
>[mailto:WanderlodgeForum@yahoogroups.com] On Behalf Of Don Bradner
>Sent: Sunday, August 24, 2008 7:51 PM
>To: WanderlodgeForum@yahoogroups.com
>Subject: Re: [WanderlodgeForum] Re: Xantrex 2.0 Hardware Inverter/Charger
>
>
>
>I blew up my Prosine 2.0 today. Had a full load of everything on at once (3
>A/C, water heater, etc.). The 50-amp breaker on the park pole went, as did
>the master breakers inside and the inverter breaker. I knew I was in
>trouble
>because the stuff on the inverter went off also. What I found after messing
>around was that the inverter is showing "relaywelddetect0"
>
>In order to have any power I have to have the Prosine off at the switch on
>the unit. Even running that way I'm getting occasional loss of power on the
>inverted circuit (which is in pass-through), which self-resets - I don't
>know what could be doing that except the inverter.
>
>On 8/24/2008 at 1:42 AM Michael wrote:
>
>>I'm glad to hear that Shane because I just purchased one. Found one
>>of those refurbished models for 60% off list and I just couldn't pass
>>it down. Where did you end up mounting yours? I'm almost afraid to
>>put it outside in a storage bin!
>>
>>Michael
>>78FC35
>>Mesa, Az
>>
>>--- In WanderlodgeForum@
>yahoogroups.com, "sfedeli3" <sfedeli3@...>
>>wrote:
>>>
>>> Hi Michael,
>>> I've had a Prosine 2.0 unit in my bird for two years with no
>>> problems. I think that most folks either install them in a closed
>>> compartment (and they overheat) or they get doused with salt or
>>> road-spray and it kills the electronics. The ProSine 2.0 is the best
>>> of the best if you ask me. I've had golf cart batteries in my coach
>>> for two years (new when I bought the prosine) that have never gassed
>>> or gotten crusty. I just water with distilled every 2-3 weeks or so
>>> with a battery watering system to keep them topped off. I've never
>>had
>>> to equalize in those two years and my Hygrometer was pegged at 1.3
>>> across all 18 cells last weekend, which is usually what I find
>>every 6
>>> months or so when I check them. You'll need to put the unit as close
>>> as possible to the battery bank and use at least 2/0 (preferably
>>4/0)
>>> cable to the battery bank. I ran 10/2 Romex up into the coach to a
>>> small sub-panel and powered all of the outlets, the ice maker,
>>> microwave and instant hot off the inverter.
>>>
>>> Shane Fedeli
>>> 85PT40
>>> Hershey, PA
>>>
>>> --- In WanderlodgeForum@
>yahoogroups.com, "Michael" <mike.putz@>
>>> wrote:
>>> >
>>> > Has anyone used or have opinions on this inverter/charger? They
>>are
>>> > selling refurbished ones for 60% off the retail price with a 1
>>year
>>> > warrenty. Could solve 2 issues for me with one stone so to speak.
>>> >
>>> > Michael
>>> > 78FC35
>>> > Mesa, Az
>>> >
>>>
>>
>>
>>
>>------------------------------------
>>
>>Yahoo! Groups Links
>>
>>
>>
Quote this message in a reply
Post Reply 


Messages In This Thread
Xantrex 2.0 Hardware Inverter/Charger - Michael - 08-20-2008, 03:23
Xantrex 2.0 Hardware Inverter/Charger - Steve Pfiffner - 08-20-2008, 05:32
Xantrex 2.0 Hardware Inverter/Charger - sfedeli3 - 08-21-2008, 04:04
Xantrex 2.0 Hardware Inverter/Charger - Michael - 08-23-2008, 13:42
Xantrex 2.0 Hardware Inverter/Charger - Don Bradner - 08-24-2008, 12:51
Xantrex 2.0 Hardware Inverter/Charger - Chuck Wheeler - 08-24-2008, 13:49
Xantrex 2.0 Hardware Inverter/Charger - Don Bradner - 08-24-2008 15:23
Xantrex 2.0 Hardware Inverter/Charger - Joe Garner - 08-25-2008, 01:47
Xantrex 2.0 Hardware Inverter/Charger - sfedeli3 - 08-25-2008, 09:51
Xantrex 2.0 Hardware Inverter/Charger - Don Bradner - 08-25-2008, 10:06



User(s) browsing this thread: 1 Guest(s)