Landing light trim - 90 SP36

[williamcharrison]

The problem isn't attaching them to the coach, the problem is that
there are 4 studs protruding from the backside of the plates to
which channel brackets get attached. When the nuts on the studs are
tightened, the brackets push the light into the opening and
at the same time hold the plate firmly against the coach.

--- In WanderlodgeForum@yahoogroups.com, Leroy Eckert
wrote:
>
> Are they 1.5" wide painted rectangular close out plates? If so and
you cannot find new ones you should be able to attach then with NP-1
caulk. If the plate actually holds the light housing you may need to
mount the light housing with counter sink screws then attach the
panel and hope never to change the lights again. I mounted every
piece of polished stainless on my coach with NP-1 and Weldwood
Contact cement.. It's been there 3 years and has not moved.
> Just a thought.
> Leroy Eckert
> 1990 WB-40 Smoke N Mirrors
> Dahlonega, GA
> Royale Conversion
>
> --- On Mon, 8/25/08, williamcharrison wrote:
> From: williamcharrison
> Subject: [WanderlodgeForum] Landing light trim - 90 SP36
> To: WanderlodgeForum@yahoogroups.com
> Date: Monday, August 25, 2008, 12:14 PM
>
>
>
>
>
>
>
>
>
>
>
> I purchased some new Hella landing lights and when I
tried to
>
> unbolt the brackets that hold the lights in place, 5 of the
>
> alum studs broke off. I saturated the studs with penetrant but
>
> they still broke off. I managed to get the plates with the
>
> broken studs off the coach but I can't press the studs out.
>
> Does anyone offer a replacement part or a repair service?
>
>
>
> Chuck Harrison
>
> Akron, Ohio
>
> 90 SP36
>