Entry Step problem

[Tom Seitz]

Jim, This happened to me on my 90sp 2 times.1st time it was a sticky
botton in the door jam, cleaned and lubed it and everthing was fine.A
few months later it was acting up again and i found a bad connection
in one of the wires under the coach by the step.Repaired the splice
and its been good. Hope this helps..Tom 90 SP36 Alpharetta GA


--- In WanderlodgeForum@yahoogroups.com, "detroitldc"
wrote:
> I have a 1991 SP36. The problem is when I got the motorhome out of
> mothballs the other day, the entry step was in the extended position,
> and it wont retract. I have tested both switches (at the front
> drivers seat and also at the step well) and they both test fine.
> There is air pressure on the cylinder, but always pressure on the
side
> that extends the step. I believe the two switches are three way, so
> when I change the switch and close the door, the step should retract.
> Any ideas?
>
> Jim Gaasch
> 1991 SP36