Fridge won't stay lit on LP

[Rick B]

I was able to test the thermocouple with a lighter, and putting a
voltmeter on the two leads. I was able to get it to 20 mV.
I am not sure if this is enough or not. So far what I've found
is some generic info on http://www.rvmobile.com that says the thermocouple
will usually put out 25-35 mV, so I'm not sure if the 20mV I am
getting is enough. When the thermocouple goes bad, does
it just not create a high enough voltage, or would it not generate any
voltage?

The local RV dealer still thought it could be the board that went bad.
Any info is still apreciated.

Thanks,
Rick Brink
87FC35 (with Dometic RM3807, w. P-711 Dinosaur Board)
Rochester, MN (currently in Grand Haven, MI)

--- In WanderlodgeForum@yahoogroups.com, "Tim Hannink"
wrote:
> It sounds like the thermocoupler - the copper bulb located next to
> the flame of the pilot light has stopped working. The one on my home
> water heater crapped out the other day and I had to have a cold
> shower this morning, the repair guy (me) should be able to fix it
> this weekend.
>
> It should be a pretty easy fix if you can get it off and to an
> appliance parts store to find a match for it. It also should be easy
> to test, it should read normally open with a multimeter at room
> temperature and should close when heated with a flame.
>
> Good luck,
>
> Tim Hannink
> Winter Park, FL
> 1981 FC-33SB
>
>
> --- In WanderlodgeForum@yahoogroups.com, "Rick B" wrote:
> > I've got a refridgeraqtor question today.
> > I have a dometic RM3807. When I switch to GAS,
> > the burner will ignite and stay lit, nice blue flame,
> > for about a minute, then it will shut off and the fridge
> > will go to "Check" status. It works fine on AC.
> >
> > I replaced the circuit board about 4 years ago with
> > one of the improved Dinosaur boards.
> >
> > Anybody have an idea of what might be causing this?
> >
> > I'm off to check rvmobile.com to see if there is anything
> > over there that might explain the problem, but if
> > anyone has any ideas I'd be happy to take them.
> >
> > Thanks,
> > Rick Brink
> > 87FC35
> > Rochester, MN