Threaded Mode | Linear Mode

10-14-2008, 10:43

That's exactly where I'm at today, trying to separate the rear turn signals from the rear brake lights.

I believe a brake light switch is located near the drive/tag axle. I'll check that out.

On Tue, Oct 14, 2008 at 3:25 PM, Scott Forman <"scottforman75@gmail.com"> wrote:

I wondered that too, found these when I was trying to figure out a way

to separate the rear turn signals from the rear brake lights. I was

not successful.

Scott Forman

86 PT38

Memphis

--- In "WanderlodgeForum%40yahoogroups.com", "Curt Sprenger"

wrote:

>

> At the top of our Gen. Fan Compartment there is a 12V panel. In that

panel

> there is marked "RH DIR" and "RH FRONT DIR (WL)", "LH DIR" and "LH

FRONT DIR

> (WL)". The WL isolators are powered the same as the R/L DIR. What is

the

> purpose of the WL isolators? Seems redundent but then it is a BB.

>

--
Curt Sprenger
1987 PT38 8V92 "MacAttack Racing"
Anaheim Hills, CA