Exhaust Update

[Jack and Liz Pearce]

--- In WanderlodgeForum@yahoogroups.com, "Kurt Horvath"
wrote:
>
>
> Exhaust Update,
>
> Still no parts from BB.
>
> Looking into 304 Stainless Steel for a custom built system.
>
> Crunched the numbers and it's about 35% more $'s
>
> I had to use an air chisel to rip the muffler off the muffler to flex
> connector pipe.
>
> Now that I'm inside the left side of the engine bay I can see I have
> a lot of work ahead of me.
>
> New insulation in the entire compartment, most of the hoses, all the
> hoses, show some sort of wear or chaffing, The hydraulic fan needs a
new
> alarmstat, I might as well get the radiator checked out because it's
> coming out. new turbo, exhaust blankets, all new clamps and rubber
> connecting boots for the radiator and intake pipes, re-engineer the
> mounting bracket for the exhaust pipe, it's to close to the turbo
> for the exhaust blankets to fit on without cramming them in. A/C
> compressor bracket need to be fixed , it's a bit worn in the mount
> holes and the pulleys are off a few degree from inline with the belts,
> wearing on one side of belts.
>
> I could go on but it's depressing. [(]
>
> Kurt Horvath
>
> 94 PT 42
>
> Ground for repairs in 10AC
>

Kurt,
I don't know if this will help you any but when our 1993 had to have a
new muffler and exhaust system, Jack worked with Ralph Fullenwider. They
used 5 " components and those worked fine. Maybe you could contact Ralph
and he could give you more information on our exhaust redo. I believe
that Ralph is listed in the membership here.

Regards,
Liz Pearce
1993 WLWB
Currently in Lakewood, NM