Horton Fan

[pattypape]

Hi Don,

With the Outside Temps in Pennsylvania, the 3208 should not get hot
enough to trip the fan temp sensor, Unless you can put a heavy load
on in the foothills. Our 88 FC trips at about 190/195 and quickly
returns to 180/185. Some one may have changed the sensor, the temp
may be stamped on the sensor, But you will probably need to remove it.
The only other way that I am avare of; is to put it is a pot of
water with Ohm meter wires attached, and with another mechanical
thermometer, and gradually raise the temp. This will check the
switching temp.

Bill 88 FC michigan

--- In WanderlodgeForum@yahoogroups.com, "Donald Spithaler"
wrote:
>
> Hi Bruce
> Will that give me the correct temp. Does yours cycle on & off a
lot? Is
> there a way to check the sensor to make sure it is coming on at the
correct
> temp? Thanks
> Don Spithaler
> 89 SP 36'
> Butler, PA
>
> On Tue, Nov 25, 2008 at 8:03 AM, birdshill123
wrote:
>
> > The sensor for the Horton fan is screwed into the block just
under the
> > alternator ( on an FC). It is a tight spot. Sensor looks just
like a
> > temperature sensor. They are wired strangely. Look closely at the
old
> > one to see both the temp. and if it is NC or NO. Mine was NC.
They are
> > available at most HD truck dealers.
> >
> > Bruce
> > 1988 FC35
> >
> >
> >
>