Stainless Steel Light Covers

[timvasqz]

Steve, the stainless inserts wont fit true unless there is a bow from
headlight to headlight. It looks like a poor attempt at a mod. The
ends wing out past headlight lines. may be a good idea to look at how
one fits befor you buy too many. I made several of them for members
with rem stainless. you can make the bow by folding lips 2 inch wider
then trim off the excess with a plasma torch. Lift the torch and add
extra heat mid cut. leaves some slag that requires extra work to
clean.

Bright stainless was too much for my bus colors. I'm thinking it
would be cool to have it brightstainless if there was a chrome bumper
but I stuck with a buff finish stainless insert because it was less
flashy and more complementary. I picked up the stainless rem sheets
for less than $20. and made 12 units before I got the curv looking
good. I notice that the buff finish must have some issues because
there is a slight rusty residu after 2 years (easy to wash off) but
the bright stuff sitting outside has no rust. could be they buff it
up with some steel or the buff material is inferior to my bright
rems.
How much are your inserts???

GregoryO'Connor
ofTim&Greg
94ptRomoland
--- In WanderlodgeForum@yahoogroups.com, "Stephen Birtles"
wrote:
>
> Stainless Steel light Covers 91-97 available december 11 just in time
> for Christmas
> From a Canadian Company but fabricated in the US
> dupreeproducts.com
>
>
> Stephen 77fc35
>