Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
air toile compressor is failing
01-11-2009, 04:20
Post: #8
air toile compressor is failing
4 compressors shot may prove compressor motor is not the problem but
the result of a problem that need attention.

1--Could it be that the limit switch on the 2nd and subsequent units
is set to start the motor when there is too much psi in the tank,
run the psi too high top end? if the tank is too small; time run
from startup to shutoff/psi-reached may be too short of a period to
run the motor and cool off the initial start up stress

wonder if there is an electronic device that could gateway startup
if voltage was under a given variable. could be that psi limit
switch now starts it up for more pressure but the battery voltage is
too low to spinn so the motor just humms and burns up

2-- Could it be that the 12 volt supply is messed up.

3--If you do a chloreen test on the discharge from the tank, lack of
will prove the water to be condensation. trace will prove other prob

4. I would ;fit a larger tank, ;mount a relay prompted switch near
the head (Momentary switch under the seat is trick), ;if belt
driven, change ratio, or ;just park near a tree

GregoryO'Connor ofTim&Greg
94pt RomolandCa
Quote this message in a reply
Post Reply 


Messages In This Thread
air toile compressor is failing - Robert Rahn - 01-09-2009, 04:19
air toile compressor is failing - Leroy Eckert - 01-09-2009, 05:41
air toile compressor is failing - jcmace59 - 01-09-2009, 09:05
air toile compressor is failing - Leroy Eckert - 01-09-2009, 10:09
air toile compressor is failing - Don Bradner - 01-09-2009, 11:48
air toile compressor is failing - luckyron1 - 01-10-2009, 19:55
air toile compressor is failing - brad barton - 01-11-2009, 03:03
air toile compressor is failing - timvasqz - 01-11-2009 04:20



User(s) browsing this thread: 2 Guest(s)