Frig. Stopped Working

[pattypape]

Good idea, you could also wire 12 volts direct to the DC heater
element.

Bill 88 FC Michigan

--- In WanderlodgeForum@yahoogroups.com, "Curt Sprenger"
wrote:
>
> Thank you all for your replies.
>
> Currently doing the standard repair/service 24 hour test... re-
wired frig.
> direct with AC (by passing ALL elec. controls). This test will tell
if the
> cooling unit is bad. Should the frig. get very cold in 24 hours
then it's
> the elec. control(s).
>
> The frig. is the original unit from the factory. Agree that it most
likely
> should be replaced, but I'm out here near Bullhead City, AZ. It
will take a
> few days to get a new frig., then to install it will take another
day. I had
> planned to arrive Quartzsite today.
>
> I just might pack food in coolers, buy dry ice, and head down to
Quartzsite
> and check out the service/repair available there.
>
> Curt Sprenger
> 1987 PT38 8V92 "MacAttack Racing"
> Anaheim Hills, CA
>
>
> On Mon, Jan 12, 2009 at 5:52 AM, pattypape wrote:
>
> > Hi Curt,
> >
> > If it is the original frig, It is time to replace,
> > The original frig get confused with the ignition key shut down, &
the
> > timing of when to return to operation and which mode to chose.
> > Depending on the model # it may need both 12 volts and 120V to
> > operate on 120 AC. It coold also be more than one problem such as
> > Electronic board, ignitor on propane and or 12 V supply, and or
> > ammonia.
> >
> > Bill 88 FC Michigan
> >
> >
> > --- In WanderlodgeForum@yahoogroups.com 40yahoogroups.com>,
> > "Curt Sprenger"
> > wrote:
> > >
> > > Our frig. stopped cooling. Was working fine yesterday. The
display
> > panel
> > > displays what is suppose to be working to cool the frig., ie.
gas,
> > 110v, 12.
> > > The unit does not cool on any of the settings. Ideas? Thanks.
> > >
> > > Curt Sprenger
> > > 1987 PT38 8V92 "MacAttack Racing"
> > > Anaheim Hills, CA
> > >
> >
> >
> >
>