1985 PT-40 Holding Tank Valve

[Glenn Allen]

Is the valve leaking past the paddle or is it leaking up past the shaft by the
handle?

You can remove the valve insert by removing two screws on top and pulling the
whole
assembly. Look for debris keeping the paddle from fully closing and inspect the
rubber for
damage. You might get by with a clean and lube or you can get new inserts from
Steve
Birtels at Cape Innovation.

Glenn



--- In WanderlodgeForum@yahoogroups.com, "curlesw" wrote:
>
> I have a small leak in the valve for the black holding tank. The valve
> is a Dupree. Looking for any insight into how to replace the valve,
> does not look to hard but not a 10 min job either. Is this a DIY job?
>
> Thanks.
>
> Wayne
> Escondido, CA
>