Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
1985 PT-40 Holding Tank Valve
02-01-2009, 13:58
Post: #8
1985 PT-40 Holding Tank Valve
It's good for the grass. If you lubricate the rubber on those valves every three months with grease you will extend their life for quite some time.
Leroy Eckert
1990 WB-40 Smoke N Mirrors
Dahlonega, GA
Royale Conversion

--- On Sun, 2/1/09, Ryan Wright wrote:
From: Ryan Wright
Subject: Re: [WanderlodgeForum] Re: 1985 PT-40 Holding Tank Valve
To: WanderlodgeForum@yahoogroups.com
Date: Sunday, February 1, 2009, 6:42 PM



Wayne,



Stephen is right, this is really easy.



I had a small leak past my black valve when I bought the Bird - every

time I removed the cap to hook the dump hose up, a gallon or two of

nasty liquid would come out. Quite embarrassing the first time it

happened in a campground while several people were admiring the Bird!



I bought two new valves from Stephen and installed them. Real easy,

remove the screws, pull the old one out, stick the new one in and

screw it back down. Nothing to it. Do make sure you fully drain your

tanks first, and I recommend you replace the valves while your dump

hose is still hooked up at the dump station.



Don't do what I did: I don't have a dump station setup at home, so I

dumped at a public station, then drive home to replace the valves. I

can only guess there was a mass of "product" stuck to the blank tank

walls that didn't dump, but fell off during the drive home, because

when I removed the valve from my just-dumped (and, I thought, empty)

black tank, a large mass of indescribable, smelly "goop" flew past the

valve location and deposited itself under my coach. There was easily

10-15 gallons of it and it was nasty, in a big nasty pile, and there

was nothing I could do but sit there for several hours hosing it down

until it dispersed into the ground. The smell lingered for days. Thank

God my neighbor on the coach-side of the house is a long time friend.



-Ryan

'86 PT-40 8V92



On 1/25/09, Stephen Birtles <"cape0001%40hotmail.com"> wrote:

>

> It is not a 10 minute job it is a five minute job

> We have the parts Give me a call 888 668 4288

> Or go to dupreeproducts. com

> Stephen 77 fc 35

> dupreeproducts. com

Quote this message in a reply
Post Reply 


Messages In This Thread
1985 PT-40 Holding Tank Valve - curlesw - 01-24-2009, 15:39
1985 PT-40 Holding Tank Valve - Glenn Allen - 01-24-2009, 16:38
1985 PT-40 Holding Tank Valve - curlesw - 01-24-2009, 16:43
1985 PT-40 Holding Tank Valve - Stephen Birtles - 01-25-2009, 02:14
1985 PT-40 Holding Tank Valve - curlesw - 01-25-2009, 04:00
1985 PT-40 Holding Tank Valve - Pete Masterson - 01-25-2009, 05:42
1985 PT-40 Holding Tank Valve - Ryan Wright - 02-01-2009, 11:42
1985 PT-40 Holding Tank Valve - Leroy Eckert - 02-01-2009 13:58
1985 PT-40 Holding Tank Valve - Stephen Birtles - 02-01-2009, 15:19
1985 PT-40 Holding Tank Valve - sfedeli3 - 02-02-2009, 04:42
1985 PT-40 Holding Tank Valve - Leroy Eckert - 02-02-2009, 04:58



User(s) browsing this thread: 1 Guest(s)