Generator Pre-Heat

[Scott Forman]

This is the same solenoid that powers the generator gauges, correct?

Scott

--- In WanderlodgeForum@yahoogroups.com, "Ralph L. Fullenwider"
wrote:
>
> Scott, the pre heat power to the glow plugs goes through a solenoid
on the
> curb side of the gen set when opened. the coil of the solenoid is
activated
> by power through contacts of C-1 relay. That is activated by either
> pressing the preheat switch on the control box or pressing the stop
side of
> the stop/start switch. Check the 12 vdc at the solenoid when
pressing the
> pre heat switch if power then solenoid is bad if no poser then go
to the
> fuse if fuse is ok then check the connectors on the terminal strip
in side
> the control box. follow your schematic. I make a copy of my
schematic from
> the book and mark the copy where I have made checks.
>
> Safe travels,
>
> Ralph and Charolette Fullenwider
> 84FC35 "Ruff Diamond"
> Duncan, Oklahoma
>
> At 05:57 PM 2/22/2009 +0000, you wrote:
> >I do not have any juice to the glo-plugs on my Yanmar generator
> >engine. Anyone have any troubleshooting tips before I start
> >investigating?
> >
> >Scott Forman
> >86 PT38
> >Memphis
> >
> >
>