Installing New Gauge in Electroluminescent Panel

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Threaded Mode | Linear Mode

Installing New Gauge in Electroluminescent Panel

03-03-2009, 12:58

Post: #1

Eric Johnson
Unregistered

Installing New Gauge in Electroluminescent Panel

I'm installing a new gauge in an empty spot on our 84FC35 instrument panel (this
is a Wanderlodge II which doesn't have all of the instruments other FC's have).
I need to cut a 2 inch hole in the panel.

I have the panel free and can see that it's clear below. Question is: Has
anyone cut a hole for a gauge in one of these panels? If so, let me know if you
have any tips on how to do it. My plan at this point is to drill a number of
small holes around the perimeter of the circle and then join them with a small
Dremel cutting tool.

Eric Johnson
84FC35SBWLII

« Next Oldest | Next Newest »

Messages In This Thread

Installing New Gauge in Electroluminescent Panel - Eric Johnson - 03-03-2009 12:58

Installing New Gauge in Electroluminescent Panel - Leroy Eckert - 03-03-2009, 13:50

Installing New Gauge in Electroluminescent Panel - Ron Thompson - 03-04-2009, 01:43

Installing New Gauge in Electroluminescent Panel - Stephen Birtles - 03-04-2009, 03:05

Installing New Gauge in Electroluminescent Panel - Ron Thompson - 03-04-2009, 03:10

Installing New Gauge in Electroluminescent Panel - Eric Johnson - 03-04-2009, 04:09

Installing New Gauge in Electroluminescent Panel - GARY MINKER - 03-04-2009, 06:42

Installing New Gauge in Electroluminescent Panel - Ron Thompson - 03-04-2009, 07:58

Installing New Gauge in Electroluminescent Panel - Wayne Kotila - 03-04-2009, 13:19

User(s) browsing this thread: 1 Guest(s)