Cannon plugs

[Curt Sprenger]

Heat, vibration, moisture, connect/disconnect, wire end(s)/connectors not the best at initial assemble, bad grounds, stress on the wire bundle or a wire in the bundle, etc., all leading to arching, deterioration and eventually no connection.


Just rewire the one bad wire outside the plugs. 

Good luck.

Curt Sprenger

1987 PT38 8V92 "MacAttack Racing"

Anaheim Hills, CA
Read all about Southwest Bluebirds and Friends (SWBB) at http://www.SOUTHWEST-BLUEBIRDS.ORG ...Then Join us.

"Host of the Annual Bluebird Quartzsite Rally"

Curt Sprenger
1987 PT38 8V92 "MacAttack Racing"
Anaheim Hills, CA
Read all about Southwest Bluebirds and Friends (SWBB) at http://www.SOUTHWEST-BLUEBIRDS.ORG ...Then Join us.

"Host of the Annual Bluebird Quartzsite Rally"

On Sat, Apr 11, 2009 at 8:08 PM, Donald Spithaler <"dspithaler@gmail.com"> wrote:

Curt    Do you know what makes one wire go bad in a plug of 24 wires?   

Don Spithaler
89 SP 36'
Butler, PA

On Sat, Apr 11, 2009 at 10:12 PM, Curt Sprenger <"curtsprenger@gmail.com"> wrote:

I'd bypass the plug. 

Curt Sprenger

1987 PT38 8V92 "MacAttack Racing"

Anaheim Hills, CA
Read all about Southwest Bluebirds and Friends (SWBB) at http://www.SOUTHWEST-BLUEBIRDS.ORG ...Then Join us.

"Host of the Annual Bluebird Quartzsite Rally"

On Sat, Apr 11, 2009 at 6:02 PM, Don Spithaler <"dspithaler@gmail.com"> wrote:

Hi Guys

I have a cannon plug with a bad wire in it. It is on the female side. Can you buy them or would it be better to bypass the wire around the plug. If you can buy them. Is there a good source.This plug has my parking lights & my 12 volt inside.

Don Spithaler

89 SP 36'

Butler, PA