Tachometer fix

[randydupree]

stop! remove the 4 bolts that hold the fan and housing to the block.pay very
close attention to the 4 bolts and the long flat bar the bolts go through.make
sure you mark the bar and put it back as removed. randydupree93wb
----- Original Message -----
From: ttikalsky
To: WanderlodgeForum@yahoogroups.com
Sent: Tuesday, June 07, 2005 1:07 AM
Subject: [WanderlodgeForum] Tachometer fix


Time to fix the tachometer. I have only owned the wanderlodge for a
few weeks, 2 short weekend trips so far, and have finally opened the
front. Luckily it has a swing radiator, looks like it was modified
after the original build, probably when the new engine was installed.
Any way I need to get the fan off, it is an electric fan and I am not
sure if this was stock I am guesing not because of the "custom" wiring
block mounted on the front of the motor to power the fan. I have
removed the large bolt in the center and I can see a shaft with a
keyway, a bearing and the fan housing. The fan spins freely on the
shaft or should I say on the bearing. Now how do I remove the fan? I
am guessing a puller is needed but not sure. Any one famaliar with
removing this type of fan?

Troy, Waconia MN 83 FC 33





------------------------------------------------------------------------------
Yahoo! Groups Links

a.. To visit your group on the web, go to:
http://groups.yahoo.com/group/WanderlodgeForum/

b.. To unsubscribe from this group, send an email to:
WanderlodgeForum-unsubscribe@yahoogroups.com

c.. Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.



[Non-text portions of this message have been removed]