Intertherm A/C shroud

[Tom Warner]

Fred this might give you an idea of what you can buy:
http://www.factoryreconditionedcatalog.c...lding.html

Tom
1982 FC35
Vernon Center,NY

At 12:31 AM 6/14/2005 +0000, you wrote:
>I tried this with some Bondo Home Solutions All Purpose Fiberglass
>Resin on a test area that I had scuffed well. The resin did not
>adhere to the shroud. Is it possible that the resin will not adhere
>to the plastic used in the shroud?
>
>
>--- In WanderlodgeForum@yahoogroups.com, Tom Warner wrote:
> > II believe if I had a shroud that was falling apart and a
>replacement was
> > not available I would remove it, fiberglass the inside and then a skim
> > coat to the outside and paint it. Has anyone tried it? I had the same
> > problem with my chassis A/C condensor which is mounted on the roof
>of older
> > Bluebirds. I made a pattern from the old shroud and made it out of
> > galvanized 14GA metal. Primed it with acid etching primer and
>painted it.
> > Cant tell the difference between the old or the new except the new
>has no
> > dents and bangs.
> >
> > tom
> > 1982 FC35
> > Vernon Center,NY
> >
> > At 05:15 AM 6/13/2005 -0700, you wrote:
> > >That's right. Hardly noticeable. I never painted the cover. If I
>had one
> > >would not know the difference at all.
> > >
> > >Curt Sprenger '87PT38, Anaheim, Calif.
> > >
> > >
> > >randydupree wrote:
> > >
> > > >curt,can you even see the differance from the ground? the sheep
>fence helps
> > > >hide all that stuff so well.....randy
> > > >----- Original Message -----
> > > >From: "Curt Sprenger"
> > > >To:
> > > >Sent: Monday, June 13, 2005 12:28 AM
> > > >Subject: Re: [WanderlodgeForum] Intertherm A/C shroud