Gauge lights will not come on

[nelson slinkman]

Thanks for all the help. I will check tomorrow on the inverter. I did make sure both rheostats were all the way clockwise. I will look for the inverters tomorrow. I did find one wire loose wire. It was a black shielded cable hanging near the rheostats but did not see any place where it would of attached to. I think the other end goes somewhere towards the front of the bus. I will have to take the front off tomorrow and try to find it. It's strange that both the dash & gauge lights went off at the same time. Thanks for the help. I will let you know what I find tomorrow. Nelson SLinkman --- On Mon, 11/9/09, gregory O wrote: From: gregory O Subject: [WanderlodgeForum] Re: Gauge lights will not come on To: WanderlodgeForum@yahoogroups.com Date: Monday, November 9, 2009, 9:28 AM Wanderlodge put in a large inverter in my 94pt in the genset rad bay. on the forward wall, left . they look like a brick, white color I found one died and I used the other one to run all the lights. the rheostats control the 12 v into the brick inverters test that the rheostat control has 12V to the input and then test that it is a voltage sliding scale on the output as wou rotatte the knob. then I would test that the voltage output is getting to the inverter then test the ac output of the inverter. I tested my el light by lighting them up with ac electric from a pepboys inverter. Greg 94ptca --- In WanderlodgeForum@ yahoogroups. com, "cape0001" wrote: > > DO NOT attach 12 volt dc directly to the dash > the dash runs on weird cycle high voltage ac. The dc is inverted to this > by 4 inverters under the dash > check the grounds on the system then the rheostat controlling the dash > check for 12 volt dc going into the inverters (Small Blue Cubes marked high voltage) > > > --- In WanderlodgeForum@ yahoogroups. com, "Fred Hulse" wrote: > > > > Nelson > > First thought is the dash dimmer switch was turned down. > > > > Fred & Jeanne Hulse > > Morristown Arizona > > 1997 Wanderlodge WLWB41 > > >