Heater part

[SteveQ]

Ron

I did not read your original post close enough. This control is on an electric
heater in your coach not the hot water system, right?

I replaced mine on the hot water system, sorry not familiar with the electric
heater. The part that I used was one of the Snap Disc Fan Controls in the
middle of the page.

Steve Quandt
1993 PT 40
Iron Mountain, MI


--- In WanderlodgeForum@yahoogroups.com, "ronmarabito2002"
wrote:
>
> Is this switch controlling the fan or the heat strip? I am not getting heat.
The fan runs all the time. Your source shows 3 different types of controls,
which is the correct type unit?
>
> R.E. (Ron) Marabito, Dallas, TX 92WB40
>
> --- In WanderlodgeForum@yahoogroups.com, "SteveQ" wrote:
> >
> > Ron
> >
> > They should be White Rodgers parts, look here at the snap disc fan controls.
> > http://www.whiterodgers.com/wrdhom/commo...ace_12.htm
> >
> > I think the one that I used was cut in at 110 and cut out at 90.
> >
> > Steve Quandt
> > 1993 PT-40
> > Iron Mountain, Mi
> >
> >
> >
> > --- In WanderlodgeForum@yahoogroups.com, Curt Sprenger
wrote:
> > >
> > > Ron,
> > > Another source...Fenwal
> > >
> > >
http://www.fenwalcontrols.com/utcfs/Temp...Id%3D\
1023%26siteId%3D375,00.html
> > >
> > > Give them a call. Inform them what you have. My guess is they will know
what
> > > you need.
> > >
> > > Curt Sprenger
> > > 1987 PT38 8V92 "MacAttack Racing"
> > > Anaheim Hills, CA
> > >
> > >
> > >
> > > On Wed, Dec 9, 2009 at 9:28 AM, Curt Sprenger wrote:
> > >
> > > > Correct size? Do you have the heater manual? It might have that
> > > > information., or direct you to a source to get the information.
> > > >
> > > >
> > > > Curt Sprenger
> > > > 1987 PT38 8V92 "MacAttack Racing"
> > > > Anaheim Hills, CA
> > > >
> > > >
> > > >
> > > > On Wed, Dec 9, 2009 at 9:21 AM, ronmarabito2002 wrote:
> > > >
> > > >>
> > > >>
> > > >> Yes Curt. How do we determine the correct size?
> > > >>
> > > >>
> > > >> R.E. (Ron) Marabito, Dallas, TX 92WB40
> > > >>
> > > >> --- In
WanderlodgeForum@yahoogroups.com,
> > > >> Curt Sprenger wrote:
> > > >> >
> > > >> > Ron,
> > > >> >
> > > >> > Look like this?
> > > >> >
> > > >> > http://www.thermodisc.com/productdetail.asp?ProductID=1
> > > >> >
> > > >> > the site has lots of them.
> > > >> >
> > > >> >
> > > >> > Curt Sprenger
> > > >> > 1987 PT38 8V92 "MacAttack Racing"
> > > >> > Anaheim Hills, CA
> > > >> >
> > > >> >
> > > >> >
> > > >> > On Wed, Dec 9, 2009 at 9:07 AM, ronmarabito2002 wrote:
> > > >> >
> > > >> > >
> > > >> > >
> > > >> > > Studying this closer, it is probably a heat sensor or thermocouple.
> > > >> > >
> > > >> > > R.E. (Ron) Marabito, Dallas, TX 92WB40
> > > >> > >
> > > >> > > --- In
WanderlodgeForum@yahoogroups.com
> > > >> ,
> > > >>
> > > >> > > "ronmarabito2002" wrote:
> > > >> > > >
> > > >> > > > Hi all: Does anyone have a source for the round disc resistor or
> > > >> > > capacitor that mounts in the top of the Bathroom Electric Heater
for a
> > > >> > > 92WB40. Mine has disintegrated and can't get heat.
> > > >> > > >
> > > >> > > > It has TOD 1-B1-B stamped on it.
> > > >> > > >
> > > >> > > > R.E. (Ron) Marabito, Dallas, TX 92WB40
> > > >> > > >
> > > >> > >
> > > >> > >
> > > >> > >
> > > >> >
> > > >>
> > > >>
> > > >>
> > > >
> > > >
> > >
> >
>