Water regulator problem?

[g_man1146]

Robert,

I had the same problem when we had our '90 PT40. The hose came off the inside of
the Regulator/Hose connection. The access to the back of the regulator is tough
to get at without removing the carper and plywood panel next to the bed. BUT,
try this first; remove the regulator from outside and see if it is still
connected to the hose that leads under the bed. If if is, disconnect the hose
under the bed and pull a new, longer piece of hose out through the exterior
regulator hole by connecting it to the disconnected hose under the bed and then
pulling out the regulator and old hose. You can then clamp the new hose to a new
regulator (available at any RV supply store), push it back in and trim and
reconnect. If the old hose is tie-wrapped you may have to pull the carpet on the
vertical panel along side the bed and remove the plywood exposing the back of
the regulator area. If remover carefully, you can put it back without any damage
for an invisible repair.

Rich D. '99LXi43' CT

--- In WanderlodgeForum@yahoogroups.com, "chaunceyboyblu"
wrote:
>
> Hello and Merry Christmas to everyone!!!
>
> We are in Olympia Washington now and are having a water issue. Been hooked up
to water pressure and heard water outside this morning and it was spewing out
from where hose goes into bus. Turned water off outside and went to pump and
the pump kept running. So, it is the white plastic thing that the hose hooks to
that is leaking. Does anyone know how to start with this problem? Do you do it
from outside or inside? If it is the regulator does anyone know where to get a
new one? Got the mattress up and looked under bed, but looks we may have to
tear some carpet up?? Any help or suggestions would be greatly appreciated!
>
> Thanks so much!
>
> Robert & Teri Rahn
> 1988 pt40
>