Backup Camera-Monitor

[Curt Sprenger]

Check the GROUND(s); bad grounds cause all sorts of strange things to happen.  Unplug the camera and reconnect it; do the same with the monitor.

Curt Sprenger
1987 PT38 8V92 "MacAttack Racing"

Anaheim Hills, CA

On Fri, Apr 30, 2010 at 7:08 PM, contrail Bob <"rhowald@frontiernet.net"> wrote:

 

Thanks Bill

No, If I turn on the key and hit reverse it works ok, when I start the coach and hit reverse the monitor goes blank. It's a touch pad shift so I doubt if there is much movement.

Thanks

Bob&Carol 99LX



--- In "WanderlodgeForum%40yahoogroups.com", Bill Mills wrote:

>

> Does this happen when the coach is not running?  That is just a curiosity questiorn, it sounds more like you are pulling on a connector enough to break the connection  when moving to the reverse position.  You might try an ohm meter at the cable that plugs into the "TV" screen end of the  cable that goes into the camera output, on the camera output end of the cable put a short.  In short, on the cable that carries the output of the camera put a short, where that plugs into the TV put an ohm meter, if you loose continuity when shifting into reverse and it returns in forward look for a work or loose connector on that cable.

> Advise is always worth what you pay for it.  Hope this is helpful.

> Bill of Huntsville

> 83 FC35

>

> --- On Fri, 4/30/10, cape0001 <sbirtles@...> wrote:

>

> From: cape0001 <sbirtles@...>

> Subject: [WanderlodgeForum] Re: Backup Camera-Monitor

> To: "WanderlodgeForum%40yahoogroups.com"

> Date: Friday, April 30, 2010, 8:03 PM

>

>

>

>

>

>

>

>  

>

>

>

>

>

>

>

>

>

> sounds like reversed wires

>

> did you change anything

>

>

>

> Stephen 97 bmc37

>

>

>

> --- In WanderlodgeForum@ yahoogroups. com, "contrail Bob" wrote:

>

> >

>

> > Hi or All, On my 99LX I have the origional sony back up camera and monitor and it works just great. The problem Iam having with it is that when I put the coach in reverse I lose the picture when I shift back into forward gear picture returns. This is a new problem as it used to work just fine, any suggestions?

>

> >

>

> > thanks

>

> > Bob&Carol Howald

>

> > Bunker Hill, Il.

>

> > 99LX-SK

>

> >

>