Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Any Idea's
06-20-2005, 05:15
Post: #2
Any Idea's
Jon,
See if a muffler shop can bend/fabricate a piece of steel
pipe to act as an extension tube you could fit into the opening
and then put the fuel filler nozzle in the extension tube.

George Witt
81 FC 35
Lincoln, Nebraska


--- In WanderlodgeForum@yahoogroups.com, "Jon" wrote:
> I went out yesterday and I was going to fill the diesel and my
> regular gas tank and ran into a problem?
>
> My bird is 33 foot long and it has a Diesel engine and a gas
> generator and there for I have two tanks.
>
> I filled the diesel tank up but when I went to fill the gas tank up I
> could not get the pump hose into the proper location to fill up the
> tank. I have a lockable door that opens and the fill pipe is located
> inside and below that door. I cannot get the nozzel to fit on the
> pipe tight and part of the fuel that I was pumping just ran over the
> side of the gas tank pipe opening. I think this is because of the new
> type of nozzels used today have a rubber seat on them and I can not
> get this into the location of this fill pipe. Anybody have this same
> problem?
>
> I can always fill by using a 5 gallon fuel can but does anyone know
> of another way? Jon
>
> Jon Lechich
> 1978 Wanderlodge
> Back-door (Rebel Bird)
> Bremerton Washington
Quote this message in a reply
Post Reply 


Messages In This Thread
Any Idea's - Jon - 06-20-2005, 02:30
Any Idea's - mrdonut12 - 06-20-2005 05:15
Any Idea's - Tom Warner - 06-20-2005, 05:22
Any Idea's - Kurt Achenbach - 06-20-2005, 06:27
Any Idea's - jon lechich - 06-20-2005, 08:49
Any Idea's - drdigger@...> - 06-20-2005, 09:45
Any Idea's - randydupree - 06-20-2005, 10:20
Any Idea's - mrdonut12 - 06-20-2005, 11:27
Any Idea's - jon lechich - 06-20-2005, 16:40
Any Idea's - geez_al - 06-20-2005, 23:46
Any Idea's - olson_phil - 06-21-2005, 00:26
Any Idea's - jon lechich - 06-21-2005, 02:27



User(s) browsing this thread: 1 Guest(s)