Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Generator tray won't extend
08-12-2010, 08:41
Post: #7
Generator tray won't extend
Yes, the switch is actuated by an extension of the locking mechanism. If
the lock is fully in the retracted position, then you can crawl under the
drivers side of the Coach and with a pair of pliers, remove the cotter pin
from the pivot pin that attaches the cylinder to the gen set tray proper.
Then slide the tray out by hand and effect repairs to the lockout switch or
wiring then re connect the cylinder remembering to replace the cotter pin
in place. Or, locate the print that shows the lock out wiring, find the
ending point and jumper that junction to tell the system the lock is
actuated. But to be honest the fastest way is to remove the clevis pin.

Safe travels,

Ralph and Charolette Fullenwider
"84FC35 "Ruff Diamond"
Duncan, Oklahoma

At 01:13 PM 8/12/2010 -0700, you wrote:


>Hi Ralph - is the switch integrated with the handle? There is a
>drip/noise panel under the rails that I'd have to remove to access the
>handle mechanism. I tried pushing the "in" switch and the pump actuated
>for a moment, so I'm guessing it's the cut off switch. Have repeatedly
>tried to push the handle all the way open. It seems to operate without any
>impediment so I think the switch is damaged or failed. Your thoughts and
>suggestions very much appreciated!
>
>Thanks
>Greg
>
>
>
>On Aug 12, 2010, at 9:21 AM, "Ralph L. Fullenwider"
><rlf47@...> wrote:
>
>>
>>
>>Greg:
>>
>>Do you have the front lock handle on your gen set? There is a cut out
>>switch if the lock is not all the way open.
>>
>>Safe travels,
>>
>>Ralph and Charolette Fullenwider
>>"84FC35 "Ruff Diamond"
>>Duncan, Oklahoma
>>
>>At 09:12 AM 8/12/2010 -0700, you wrote:
>
Quote this message in a reply
Post Reply 


Messages In This Thread
Generator tray won't extend - Greg Young - 08-11-2010, 06:48
Generator tray won't extend - Al Scudder - 08-12-2010, 03:26
Generator tray won't extend - Greg Young - 08-12-2010, 04:12
Generator tray won't extend - Steve Quandt - 08-12-2010, 04:19
Generator tray won't extend - Ralph L. Fullenwider - 08-12-2010, 04:21
Generator tray won't extend - Greg Young - 08-12-2010, 08:13
Generator tray won't extend - Ralph L. Fullenwider - 08-12-2010 08:41



User(s) browsing this thread: 2 Guest(s)