Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Driver's Side Front Bay Door Won't Open on 1993 Wanderlodge
12-10-2010, 09:25
Post: #2
Driver's Side Front Bay Door Won't Open on 1993 Wanderlodge
Can you reach in from the generator side and stick your hand in with your digital camera and shoot some shots? I do that in tight places when I am remodeling to look for hidden wires.
Sounds like the rear (out of sight) lock is not disengaging or the body work is holding the door after it slide forward (maybethe collars with the set screws that set the fore and aft travel on the access door came loose and allowed it to move foreward or aft and bind with the sheet metal frame.)



From: txfulltimers
To: WanderlodgeForum@yahoogroups.com
Sent: Fri, December 10, 2010 3:18:28 PM
Subject: [WanderlodgeForum] Driver's Side Front Bay Door Won't Open on 1993 Wanderlodge




İmage Driver's Side Front Bay Door Won't Open

Howdy.
The driver's side front bay door won't open on my 1993 WLWB. It is the bay that has the generator cooling fan in it. By lying on the ground, I have removed all of the **** from that compartment that I could reach from it's floor opening. But I can't get around that cooling fan. Facing the coach, I can see the rod moving when Liz pulls up on the outside latch but I can't see the rod on the far side of the door. So I don't know what it is doing. I am carefully removing the bolts on the very bottom of that entire compartment to ease the floor open a very small amount. Hopefully then I can see if that other rod is moving. Then maybe I can see if it is being stopped from moving by some obstruction on the floor of that compartment. Suggestions or ideas would be very welcome.

TIA,
Jack
Regards,
Jack and Liz Pearce
Fulltiming in a 1993 Wanderlodge WB40
D'Hanis, TX
Winter
Buena Vista, CO Summer


Quote this message in a reply
Post Reply 


Messages In This Thread
Driver's Side Front Bay Door Won't Open on 1993 Wanderlodge - Robert Johannesen - 12-10-2010 09:25



User(s) browsing this thread: 1 Guest(s)