Threaded Mode | Linear Mode

04-30-2011, 20:16

We wound up trashing the Microphor. Good riddance!! But the Vetus Macerator
(WC12L2) installation was not easy. The nearest 12 vt wire was in the chase on
the outside wall and too thin. It was only 14 gauge, so we couldn't use it
because the toilet is wired with 12 gauge and the manual stipulated a 30 amp
fuse, go figure. Anyway, we started the 10 gauge wire in the inverter bay (which
is on the middle of the passenger side) with a 30 amp resettable breaker,
forward to the cage wall, then across to the driver's side, then back to come up
thru the chase between the kitchen and bathroom, then into the wall behind the
toilet to the drain outlet, and out to the back of the toilet. We put the switch
on the chase beside the toilet. Very clean. As usual, a very professional job by
a former Prevost tech now domiciled near San Antonio, Stagecoach RV Service. We
recommend him highly.

2000 LXI
About to leave for MN