Need to replace starting batteries.

[Gary Smith]

I don't own a BB, but would advise you to sketch out a diagram of your batteries as they sit in the tray, marking both positive and negative terminal locations. Then, using masking tape or labels, label your cable connections from left to right (for example: L+1, L+2, L-1, etc.), and annotate on your sketch. Be sure to get every cable, regardless of size. This will allow you to get the new batteries oriented properly and reconnect all the cables to the right terminal of the right battery.

Gary

SOB

Sent from Gary's iPhone

On May 7, 2011, at 12:00 PM, "Fred Hulse" <"fhulse@wildblue.net"> wrote:

Hi Nelson

To buy batteries for your chassis it’s a good idea to buy from a supplier you do business with and will be there for you if you have any warranty issues in the future.

There should be a Cole Hersee battery switch just above the batteries on the firewall you need to turn to the off position before doing any work.Also remove any 110 V

source and turn of the inverter(s).Use baking soda and water for cleaning the tray and cables also.Just remember battery acid is corrosive.

It is also a good idea to take a picture of the setup before you begin in case you are interrupted for any reason.

Fred & Jeanne Hulse
Morristown,Arizona
97 WLWB41