Need to replace starting batteries.

[nelsons]

Hello Ron,
I just traced the "Orange Wire". It went back to the Electrical connection for
the trailer Hitch. I was the second owner of the coach. The previous owner must
have used this to charge his car battery or maybe a trailer light. I am just
going to remove it.
Thanks
Nelson
Westminster, Md 40' WB
--- In WanderlodgeForum@yahoogroups.com, Ron Thompson wrote:
>
> Its probably a circuit that someone added for a particular reason. Does it
look like someone just attached the Orange wire to the battery terminal or does
it look like a factory job. As long as you put it back where it belongs there
is no reason to fret.
>
> Ron Thompson -Waller, Tx.
>
> 1995 WLWB 42'
>
> (cockyfox@...)
>
> --- On Sat, 5/7/11, nelsons wrote:
>
> From: nelsons
> Subject: [WanderlodgeForum] Re: Need to replace starting batteries.
> To: WanderlodgeForum@yahoogroups.com
> Date: Saturday, May 7, 2011, 11:57 AM
>
>
>
>
>
>
>
> Â
>
>
>
>
>
>
>
>
>
> Thank You for the information Fred.
>
> I just checked my batteries and could not find a Cole Hersee battery switch.
It looks like the hot side of the batteries are attached to an isolated bolt on
a piece of aluminum behind the bank of batteries. The negative sides are also
attached to two bolts on the piece of aluminum. One at the start of the
batteries and one on the other end of the batteries. My only concern is this
orange wire with an inline fuse attached to the plus side of the first battery.
Not sure what this is for. Could not find any info in my documentation.
>
> Thanks
>
> Nelson
>
> Westminster, Md 40ft WB
>
>
>
> --- In WanderlodgeForum@yahoogroups.com, "Fred Hulse" wrote:
>
> >
>
> > Hi Nelson
>
> > To buy batteries for your chassis it’s a good idea to buy from a
supplier you do business with and will be there for you if you have any warranty
issues in the future.
>
> > There should be a Cole Hersee battery switch just above the batteries on the
firewall you need to turn to the off position before doing any work.Also remove
any 110 V
>
> > source and turn of the inverter(s).Use baking soda and water for cleaning
the tray and cables also.Just remember battery acid is corrosive.
>
> > It is also a good idea to take a picture of the setup before you begin in
case you are interrupted for any reason.
>
> > Fred & Jeanne Hulse
>
> > Morristown,Arizona
>
> > 97 WLWB41
>
> >
>