Tire fitment question
|
03-12-2013, 10:16
Post: #1
|
|||
|
|||
Tire fitment question
Has anyone replaced their 12R22.5 tires with the new 315/80R22.5 tires on a 90's
era wide body coach with the fiberglass fenders? Preferably a 91 coach. Are there any clearance problems on the front when turning, or when at rest and aired down? The reason I ask is because the 315s are a full 1.1" wider than the 12Rs and I barely have room to get my hand between the front fiberglass fenders and the 12Rs when the air is down. For people trying to learn about Birds, because of that, you make sure your front tires are pointed straight ahead when dropping the air suspension. Also, what about the clearance between the drive axle duals with the 315s? They call for a minimum dual spacing of 13.8" versus 13.2" for the 12Rs on there now. Finally, I note that all the Michelin sites seem to say check with them if you have 8.25" rims, which is what we have on the widebody 90s era Birds. Is there a problem there? They list both 9.0 and 8.25 as approved rims, so why the need to check with them? On the plus side, the 315s come in Load Range L, which is a very nice step up from the 12Rs which are Load Range H. So you go from 6780 lbs. max load per single to a whopping 9090 lbs. max load per tire on the singles. That's very attractive on the fronts especially. Even more of a plus, the 315s are about $60 less per tire but about $16 more on FET, so they are each still about $44 cheaper when you net it out. Thanks for any input folks. Mike Bulriss 1991 WB40 "Texas Minivan" San Antonio, TX |
|||
« Next Oldest | Next Newest »
|
Messages In This Thread |
Tire fitment question - mbulriss - 03-12-2013 10:16
Tire fitment question - Wilhelmus Schreurs - 03-14-2013, 05:26
Tire fitment question - Don Bradner - 03-14-2013, 09:15
Tire fitment question - tulipvendor50 - 03-14-2013, 18:23
Tire fitment question - Don Bradner - 03-14-2013, 18:43
Tire fitment question - Michael Bulriss - 03-15-2013, 01:49
Tire fitment question - Joe Garner - 03-15-2013, 05:23
Tire fitment question - Don Bradner - 03-15-2013, 05:46
Tire fitment question - Joe Garner - 03-15-2013, 06:46
|
User(s) browsing this thread: 1 Guest(s)